<em>Nissan Atlas</em> fuse diagram: location, purpose and replacement

Nissan Atlas is a commercial pickup truck built on the basis Nissan Navara and adapted for the markets of Southeast Asia and Latin America. Like any modern car, it is equipped with complex electronics protected by fuses. But when any device stops working - be it the headlights, the cigarette lighter or the climate control system - the first thing you should check is fuse box.

In this article you will find current fuse and relay diagrams for Nissan Atlas (including restyled versions 2023–2026), learn where the main units are located, how to correctly diagnose a fault and replace a blown fuse without the risk of damaging the electrical system. We will also look into typical mistakes that owners make when working with fuses, and we will give recommendations on choosing spare parts.

Where are the fuse boxes located in Nissan Atlas

B Nissan Atlas provided two main fuse boxes:

• 🔧 Main unit in the cabin — located to the left of the steering column, behind the protective cover. Fuses for most systems are concentrated here: lighting, multimedia, climate control, etc.
• 🚗 Additional block under the hood - located next to the battery (in some versions - under a plastic cover near the air filter). Responsible for high-voltage circuits: starter, generator, cooling fans.

Also in some configurations may be present third block — in the luggage compartment (for example, for system fuses Nissan Intelligent Mobility or additional equipment). However, in basic versions Atlas it is rare.

To gain access to the cabin unit, it is enough open the lid, prying it off with a flat screwdriver or plastic card. The lid is usually secured with latches - do not use excessive force to avoid breaking the fasteners. Under the hood, the fuse box can be covered with a rubber boot to protect it from moisture.

Interior block fuse diagram (2020–2026)

Below is the current diagram for Nissan Atlas all years of production (including restyling 2023). Please note that fuse ratings may vary slightly depending on the configuration (for example, in versions with Pro-4X or SL added fuses for off-road systems).

Fuse no.	Denomination (A)	Purpose	Notes
F1	10	Engine control system (ECU)	Burns out due to a short circuit in the sensor harness
F5	15	Cigarette lighter/socket 12V	Often fails when connecting powerful devices (for example, compressors)
F10	7.5	ABS control unit	May burn out if the wheel sensors are faulty
F14	20	Heater fan	Check if there is no airflow at any speed
F20	10	Audio/navigation	Responsible for powering the head unit

Full diagram for your version Atlas can be found in instruction manual (section Fuses and Relays) or on the sticker on the back of the unit cover. If the sticker has worn off, download the electronic version of the manual on the official website Nissan (enter your vehicle's VIN for an exact match).

⚠️ Attention: Never replace a fuse with a component with large denomination, even if you don’t have what you need at hand! This may lead to fire in the wiring or failure of expensive modules (for example, ECU).

How to check the fuse in Nissan Atlas: step by step instructions

If an electrical device in your car stops working (for example, the headlights don't light up or the power window doesn't work), first check the corresponding fuse. To do this you will need:

• 🔦 Flashlight (for inspecting the block in the dark).
• 🛠️ Tweezers or a special fuse puller (usually included with the car).
• 🔍 Magnifying glass (optional, for checking small fuses).
• 📱 Tester (multimeter) or 12V test lamp.

Turn off the ignition and remove the negative terminal from the battery

Find the fuse number in the diagram (see table above)

Remove the fuse with tweezers (do not use metal tools!)

Inspect the wire element for breakage or melting

Check the circuit with a tester (resistance should be close to 0 ohm) -->

If the fuse is blown, it must be replaced with a new one same denomination. As a last resort, you can temporarily use a fuse from another circuit (for example, from heated seats, if it is not needed at the moment), but only if their ratings match!

After replacement, check the operation of the device. If the new fuse blows immediately, this indicates short circuit in the circuit. In this case, do not attempt to reinstall the fuse - contact an electrician for diagnosis.

Relay diagram in Nissan Atlas: purpose and typical faults

In addition to fuses, in blocks Nissan Atlas located relay, which control high-voltage circuits. Unlike fuses, relays do not "blow" but may stick (contacts are welded) or fail due to oxidation. Below are relay diagrams for the interior and engine compartment units.

Designation	Purpose	Symptoms of a problem
R1	Starter relay	The engine does not start or clicks when you turn the key
R3	Cooling fan relay	Engine overheating, fan does not turn on
R5	Fuel pump relay	The engine does not start, there is no sound of the pump when the ignition is turned on
R7	Fog light relay	PTFs do not turn on or are constantly on

To check the relay, you can swap it with a known good one (for example, a horn relay). If after replacement the problem disappears, the relay is faulty. You can also check the relay with a tester:

1. Set the multimeter to resistance test mode (200 ohms).
2. Connect the probes to the contacts 85 And 86 (relay coil). Resistance must be within 50–120 Ohm.
3. Apply 12V to the contacts 85 And 86 - a click should be heard (contacts closing 30 And 87).

⚠️ Attention: If the relay heats up during operation (eg fan relay), this may indicate problems in the circuit (short circuit or increased load). Don't ignore this symptom!

Typical problems with fuses in Nissan Atlas and their solutions

Owners Nissan Atlas often encounter several common faults related to fuses. Let's look at the most common cases and ways to eliminate them.

Why does the cigarette lighter fuse keep blowing?

Most often this occurs due to the connection of devices with high current consumption (for example, car refrigerators or compressors with a power of more than 150 W). Solution:

1. Use a power strip with a separate fuse.

2. Connect powerful devices directly to the battery through an additional fuse.

3. Check the socket for oxidation of the contacts (this increases resistance and heat).

Problem 1: The headlight fuse (F17, 10A) blows.

Reasons:

• 💡 Short circuit in the lamp (for example, when installing low-quality LED lamps).
• 🔌 Damage to the wiring in the headlight unit or steering column switch.
• 🌧️ Moisture getting into the headlight (especially important after pressure washing).

Solution: Replace the lamps with original ones, check the tightness of the headlight and the condition of the wiring. If the problem persists, contact an auto electrician to diagnose the harness.

Problem 2: The window regulator does not work (fuse F22, 25A).

In this case, not only the fuse is to blame, but also:

• 🔄 Wear of the brushes of the electric window lifter motor.
• ⚡ Short circuit in the control button (especially if the glass “snacks”).
• 🔧 The mechanism cable is broken (in this case, the fuse may remain intact, but the glass does not move).

How to choose quality fuses for Nissan Atlas

Not all fuses are created equal. Cheap Chinese analogues can:

• 🔥 Have an inaccurate rating (for example, instead of 10A - 8A or 12A), which leads to false positives or, conversely, does not protect the circuit.
• 🛑 Oxidize quickly, increasing resistance and heating.
• 💥 Explode when overloaded (instead of fusing).

Recommended fuse brands for Nissan Atlas:

• 🏆 Littlefuse - original fuses used on the conveyor Nissan.
• 🥈 Bussmann - high quality fuses with precise ratings.
• 🥉 Eaton (Cooper) - reliable and affordable.

When purchasing, pay attention to:

• 📏 Size: in Atlas fuse types are used Mini (small) and Regular (standard).
• 🔢 Denomination: must exactly match what is indicated in the diagram (for example, 10A, not “about 10A”).
• 🏷️ Certification: there must be a sign on the packaging ISO 9001 or SAE J1284.

Avoid fuses labeled as "Universal" or "Fit All" - they rarely meet standards Nissan.

Frequently asked questions (FAQ)

Is it possible to use a "bug" instead of a fuse in Nissan Atlas?

No! Installing a wire bug instead of a fuse can lead to fire in the wiring or failure of electronic units (for example, ECU or ABS unit). If the fuse constantly blows, this is a signal about short circuit — it is necessary to diagnose the circuit, and not ignore the problem.

Where can I find a fuse diagram for Nissan Atlas 2026?

For the latest versions Atlas (2026 model year) diagram can be:

1. Download from the official website Nissan by VIN number (section Owner’s Manuals).
2. Find it on the sticker under the fuse box cover (if the car is new).
3. Request from the dealer (sometimes diagrams are updated with restyling).

Please note: system fuse ratings may have changed in 2026 ProPILOT And Intelligent Around View Monitor.

What should I do if, after replacing the fuse, the device still does not work?

Possible reasons:

• The fuse is not installed correctly (check that it is seated tightly in the socket).
• The device itself is faulty (for example, a lamp or motor has burned out).
• The problem is in the wiring or control unit (diagnosis with a scanner is required).
• The relay responsible for this circuit has burned out.

Start by checking contact voltage fuse when the ignition is on (should be 12V). If there is no voltage, the problem is in the wiring or fuse box.

Is it possible to change the fuse box yourself? Nissan Atlas?

Theoretically yes, but this not recommended no experience. The fuse block is not only a board with sockets, but also a part can-tires (data exchange networks between electronic units). If the connection is incorrect, you can:

• 🚨 Disable the immobilizer.
• 📵 Disable system NissanConnect.
• 🔋 Reset all electronic systems.

If the unit is physically damaged (for example, after an accident or moisture), it is better to contact the service.