Crossover Nissan Murano Z52 (second generation, 2007–2014) is a popular choice among owners who value comfort and off-road capabilities. However, even such a reliable car requires attention to detail, especially when it comes to wheel sizes. Incorrect selection of tires or wheels can lead to handling problems, increased suspension wear, or even failure to pass inspection.
In this article we will look at original wheel sizes for Murano Z52, acceptable alternatives, the influence of non-standard parameters on the behavior of the car, and we will give practical recommendations for choice. We will pay special attention to nuances that are often overlooked: from load index to system compatibility ESP.
Original wheel sizes for Nissan Murano Z52
Factory wheel parameters for Murano Z52 depend on the configuration and year of manufacture. Basic versions were equipped with 17-inch wheels, while top versions (for example, LE or SL) received 18- or 20-inch wheels. Below is a table with official manufacturer data.
| Equipment | Tire size | Disk size | Departure (ET) | PCD (bolt pattern) |
|---|---|---|---|---|
| Base / S (2007–2010) | 235/65 R17 | 7.5J×17 | 40 mm | 5×114.3 |
| SL (2007–2014) | 235/55 R18 | 8J×18 | 40 mm | 5×114.3 |
| LE (2011–2014) | 235/45 R20 | 8.5J×20 | 45 mm | 5×114.3 |
| CrossCabriolet (2011–2014) | 235/50 R19 | 8J×19 | 40 mm | 5×114.3 |
Please note: Wheels with an offset (ET) of less than 35 mm or more than 50 mm may interfere with suspension components or arches. Bolt pattern 5×114.3 standard on most models Nissan, but when replacing discs it is important to check compatibility with the hub (the diameter of the central hole is 66.1 mm).
⚠️ Attention: Installing wheels with the wrong offset (ET) leads to accelerated wear of wheel bearings and ball joints. Even if the wheel visually falls into place, the risk of breakage remains.
Acceptable alternative tire and wheel sizes
Many owners Murano Z52 want to install wheels of larger or smaller diameter. Important to remember: changing tire size affects speedometer readings, ground clearance And transmission load. Below are proven options that do not require modifications.
- 🔄 17-inch wheels: instead of
235/65 R17can be used225/70 R17(increases ground clearance by ~10 mm) or245/60 R17(wider, but reduces comfort). - 🔄 18-inch wheels:
235/55 R18is replaced by225/60 R18(softer) or245/50 R18(sports version). - 🚫 20-inch wheels: It is not recommended to install thinner tires
235/45 R20— this worsens directional stability at high speeds. - ⚠️ 19-inch wheels: only suitable for CrossCabriolet. On other modifications, you will need to check the gaps in the arches.
When selecting alternative sizes, use tire calculator (for example, on the website TireRack or Blackcircles), to ensure that the overall diameter of the wheel differs from the original by no more than ±3%. Exceeding this threshold will result in malfunctions ABS And ESP.
- 17 inches
- 18 inches
- 19 inches
- 20 inches
- Other
The influence of wheel size on driving performance
Changing the wheel size is not only aesthetics, but also a change in the technical characteristics of the car. Let's look at the key aspects:
- 📉 Reducing the disc diameter (for example, from 18 to 17 inches):
- Pros: soft ride, cheap tires, less risk of wheel damage in pits.
- Cons: Poor handling at high speeds, less sporty appearance.
- 📈 Increasing diameter (for example, from 17 to 20 inches):
- Pros: better directional stability, stylish appearance.
- Cons: rough ride, high cost of tires, risk of damage to the rims on uneven surfaces.
- ⚖️ Changing tire width: wider tires (
245/50 R18instead of235/55 R18) improve grip on dry asphalt, but can worsen handling on wet roads and increase fuel consumption.
The ratio of wheel size to transmission ratios. For example, installing tires with a smaller outside diameter will cause the engine to run at higher speeds, which will increase fuel consumption. The opposite situation (larger diameter) will reduce the acceleration dynamics.
Before purchasing non-standard wheels, check that they are compatible with the spare wheel (if it is a spare wheel). In some cases, the “dokat” may not be suitable in diameter or width.
How to choose the right tires for the Murano Z52
Selecting tires for Nissan Murano Z52 depends on operating conditions. Here are the key criteria:
- Seasonality:
- 🌞 Summer tires: the best choice for city driving - Michelin Primacy 4, Continental ContiPremiumContact 6.
- ❄️ Winter tires: Suitable for snow and ice Nokian Hakkapeliitta R3 or Bridgestone Blizzak DM-V2.
- 🍂 All-season tires: a compromise option, but in Russian conditions it is better to avoid - they are inferior to specialized tires both in summer and winter.
100 (800 kg per wheel), speed - T (up to 190 km/h) or H (up to 210 km/h).No less important year of tire production. Even if the tread looks new, tires older than 5 years lose elasticity and become dangerous. Check the production date on the side (four digits in an oval, e.g. 2523 - 25th week of 2023).
☑️ Check before purchasing tires
Common mistakes when choosing wheels
Even experienced car owners make mistakes when selecting wheels for Murano Z52. Here are the most common:
- 🔧 Ignoring departure (ET): discs with incorrect offset shift the center of gravity of the wheel, which leads to uneven wear of the bearings. For example, installing disks with
ET 30instead ofET 40will increase the load on the hub. - 📏 Non-compliance with diameter: tires with an outer diameter that differs from the original by more than
3%, confuse the speedometer readings and can cause errors ABS. - ⚡ Savings on speed index: tires with index
S(up to 180 km/h) not suitable for Murano Z52, since the car is capable of achieving high speed. - 🔄 Incompatibility with TPMS system: If your car is equipped with pressure sensors, the new rims should support their installation.
⚠️ Attention: Installation of tires with a lower load index 100 (800 kg) are dangerous - when the car is fully loaded (5 passengers + luggage), they can burst at high speed.
Another typical mistake is buying used tires with a remaining tread depth of less than 4 mm. For winter tires this figure should be at least 6 mm, otherwise traction on snow and ice will deteriorate sharply.
Recommendations for caring for wheels
Proper care of wheels extends their service life and ensures safety. Follow these tips:
- 🔄 Regular rearrangement: change wheels every time
10,000–15,000 km(according to the “criss-cross” or “front-to-back” pattern). This will ensure even wear. - 🛠️ Balancing: Carry out balancing at each seasonal tire change or after a strong impact (for example, falling into a hole). Imbalance leads to vibration of the steering wheel and accelerated wear of the suspension.
- 📈 Pressure control: Check your tire pressure at least once a month. For Murano Z52 recommended pressure:
- Front wheels:
2.2–2.4 bar(depending on load). - Rear wheels:
2.4–2.6 bar.
- Front wheels:
- 🧼 Disk cleaning: use special brake dust removers (for example, Sonax Full Effect). Abrasive scourers and aggressive chemicals damage the paintwork.
Pay special attention tire storage. Summer tires in winter (and vice versa) should be stored in a dry, cool place, hung on special racks or stacked (but no more than 4 tires in one stack). Avoid direct sunlight - ultraviolet radiation destroys rubber.
What happens if you drive on flat tires?
Reduced pressure increases the contact patch, which leads to overheating of the tire and the risk of it bursting. In addition, fuel consumption increases (up to 5%) and sidewall wear accelerates. The ESP system may not work correctly due to incorrect data from the ABS sensors.
Where to buy wheels for Nissan Murano Z52
When purchasing wheels for Murano Z52 It is important to choose a reliable supplier. Here are the tested options:
- 🏬 Official dealers Nissan: they guarantee original spare parts, but prices are 20–30% higher than market prices. Suitable for those who value warranty and documentation.
- 🛒 Specialized tire shops: for example, Koleso.ru, Shina.ru or BlackTyres. Here you can choose analogues of original wheels and tires with savings of up to 40%.
- 🌍 Foreign online stores: TireRack (USA), Oponeo (Europe). Prices are lower, but you will have to take into account delivery and possible duties.
- 🔄 Used market: suitable for a budget option, but requires careful checking (see section "Common mistakes"). It is better to buy from trusted sellers with a guarantee.
When purchasing online, be sure to check:
- Availability of certificates of conformity (especially for disks).
- Possibility of return if the wheels do not fit.
- Delivery times (during the tire changing season, delays can reach 2-3 weeks).
Before purchasing wheels, be sure to check the VIN code of your car - some modifications of the Murano Z52 have unique parameters that are not listed in the general tables.
FAQ: Frequently asked questions about wheels for Nissan Murano Z52
Is it possible to fit 22-inch wheels on the Murano Z52?
Technically possible, but serious modifications will be required: trimming the arches, replacing shock absorbers and springs with shortened ones. In addition, such discs are extremely inconvenient for Russian roads - there is a high risk of damage if they fall into a hole. We recommend limiting yourself to the maximum factory size - 20 inches.
What pressure should 235/55 R18 tires have?
For Murano Z52 with tires 235/55 R18 recommended pressure:
- Front wheels:
2.3 bar(at full load -2.5 bar). - Rear wheels:
2.5 bar(at full load -2.7 bar).
The pressure is indicated for cold tires (the car has not been driven for at least 2 hours).
Which is better: 17 or 18 inches for winter?
Preferable for winter use 17" wheels with tires 235/65 R17. Benefits:
- The high profile height of the tires provides better grip on snow and comfort on uneven surfaces.
- There is a lower risk of damage to discs if they fall into a hole.
- Cheaper to maintain (17-inch tires and wheels cost less).
18-inch wheels are suitable if you drive mainly on clear city roads.
What offset (ET) is suitable for 20" wheels?
For Murano Z52 with 20-inch wheels optimal offset - ET 45 mm. Acceptable range: ET 40–50 mm. Discs with offsets outside this range may interfere with suspension or arch components, especially when the vehicle is fully loaded.
Can tires with different treads be used on the same axle?
No, this is strictly prohibited. Different tread patterns on the same axle result in uneven traction, which can cause skidding or loss of control. Particularly dangerous on wet or icy surfaces. It is allowed to install tires with the same tread, but different degrees of wear (for example, new in the front, half worn out in the back).