Rearview mirror <em>Nissan Qashqai J11</em>: how to select, replace and configure

Nissan Qashqai J11 is one of the most popular crossovers on the Russian market, and its owners are often faced with the need to replace or adjust rear-view mirrors. This may be due to mechanical damage, failure of electronics (for versions with heating and electric drive) or simple wear and tear. In this article we will look at all the nuances: from the choice of original and non-original mirrors to step-by-step instructions for dismantling and installation.

We will pay special attention typical problemsproblems that owners face Qashqai J11 (2014–2021): glass fogging, heating malfunctions, loose fasteners and system compatibility Around View Monitor. You will also find unique spare parts articles for different configurations, including versions with cameras and rain sensors.

Types of rear view mirrors for Nissan Qashqai J11: how are they different?

Mirrors for Qashqai J11 are divided into several categories depending on the vehicle configuration. The main differences relate to the presence of additional functions:

• 🔄 Mechanical mirrors — basic version without electronics, manually adjustable. Installed on minimal configurations (for example, Visia).
• ⚡ Electric mirrors — with motors for remote adjustment from the cabin. Standard for most versions (Acenta, N-Connecta).
• 🔥 Heated mirrors — equipped with a heating element to remove condensate. Often combined with an electric drive.
• 📹 Mirrors with camera — for all-round viewing systems (Around View Monitor). Installed on top-end configurations (Tekna, Tekna+).
• 🌧️ Mirrors with rain/light sensor — integrated into the body to automatically turn on the wipers and headlights.

It is important to consider that mirrors are for Qashqai J11 not interchangeable with models J10 (first generation) or J12 (restyling 2021). Even externally similar parts may differ in connection connectors or fasteners. For example, a mirror with a camera from J11 not suitable for J12 due to a changed data transfer protocol.

Original articles and analogues: how not to make mistakes when purchasing

When choosing a mirror for Nissan Qashqai J11 it is critical to know the exact original part number. Below is a table with the most common options:

Mirror type	Original article	Side	Notes
Mechanical (without heating)	26550-JM00A (left), 26500-JM00A (right)	Left/right	For basic configurations
Electric heated	26550-4M01A (left), 26500-4M01A (right)	Left/right	With power connector
With camera (Around View)	26550-4M02A (left), 26500-4M02A (right)	Left/right	Only for versions with surround view system
With rain sensor	26550-4M03A	Left	Includes sensor for automatic wipers

When purchasing analogues, pay attention to the manufacturer. The following brands have a good reputation:

• 🇯🇵 Denso - original supplier for Nissan, high quality, but the price is close to OEM.
• 🇰🇷 Mando — Korean manufacturer, optimal price/quality ratio.
• 🇹🇼 TYC — Taiwanese mirrors, a budget option, but there may be problems with the durability of the plastic.
• 🇪🇺 Hella - European quality, often supplied in heated sets.

⚠️ Attention: When purchasing a mirror with a camera, check compatibility with your system Around View Monitor. Parts for 2014–2017 models. may not fit restyled versions 2018–2021. due to a change in the multimedia system firmware.

Step-by-step instructions for replacing a rear view mirror

Replacing the mirror with Nissan Qashqai J11 does not require special skills, but it is important to follow the algorithm so as not to damage the wiring or fastenings. Below are universal instructions for most types of mirrors.

Disconnect the negative terminal of the battery (to avoid short circuit)

Have a flathead screwdriver or plastic pick ready to remove the trim

Prepare a new mirror and check the completeness (mounts, seals)

If the mirror is electric, take a photo of the connectors before disconnecting it-->

Step 1: Removing the inner door trim

Remove the plastic trim on the inside of the door. To do this:

1. Using a screwdriver, carefully pry the clips around the perimeter of the panel (starting from the bottom corner).
2. Disconnect the wiring connectors from the power window and mirror control buttons.
3. Remove the trim and set it aside to avoid damage.

Step 2: Disabling the old mirror

Inside the door you will see three nuts for securing the mirror (wrench to 10 mm). Unscrew them and carefully pull the mirror out, having first disconnected the power connector (if the mirror is electric). For mirrors with a camera, there will be two connectors: one for power, the second for video transmission.

Step 3: Installing a New Mirror

Before installing a new mirror:

• 🔌 Check the integrity of the wiring and connectors.
• 🧴 Apply silicone grease to the O-ring for a tight seal.
• 🔧 Tighten the fastening nuts without overtightening (tightening torque - 8–10 Nm).

Step 4: Build and Test

Reinstall the door trim, connect all connectors and check the operation of the mirror:

• For electric mirrors: test the adjustment using the joystick on the door.
• For heated mirrors: turn on the function and make sure that the glass is heated evenly.
• For mirrors with a camera: check the image on the multimedia system screen in Around View.

Adjusting your mirrors: how to avoid blind spots

Correctly adjusting the rear view mirrors Qashqai J11 - a guarantee of safety on the road. Many drivers mistakenly believe that mirrors should completely duplicate the view of the rear window, but this leads to the appearance blind spots. The optimal setting looks like this:

Left mirror:

• 👁️ The driver must see 1/4 rear fender car.
• 🚗 The rest 3/4 view - the road is behind.
• 📏 The horizon should divide the mirror approximately in half.

Right mirror:

• 🔄 Set it up so you can see 10–15 cm of rear bumper.
• 🚛 The viewing angle should cover the adjacent lane (to control overtaking).
• ⚠️ Avoid excessive downward tilt - this increases the blind spot to the side.

For power mirrors, adjustment is carried out using the joystick on the driver's door. If the mirrors do not remember their position when the ignition is turned on, there may be problems with the control unit BCM (Body Control Module) or mirror position sensor.

How to check the mirror position sensor?

If the power mirrors do not return to the stored position, follow these steps:

1. Turn on the ignition.

2. Press the mirror folding button (if any) - they should fold and return to their original position.

3. If the mirrors do not move or return to the wrong position, the Hall sensor in the drive mechanism is most likely faulty. In this case, the entire mirror unit must be replaced, since the sensor is not supplied separately.

Common problems and their solutions

Owners Nissan Qashqai J11 often encounter typical mirror malfunctions. Let's look at the most common cases and ways to eliminate them.

1. The mirror is not adjustable with the joystick

Reasons:

• 🔌 The fuse has blown F37 (10A).
• 🔧 Broken wiring in the corrugation between the door and the body.
• ⚙️ Drive motor malfunction.

Solution: Check the fuse, inspect the wires for breaks (especially at the bend). If the motor does not work, the mirror unit will need to be replaced.

2. Heated mirror does not work

Reasons:

• 🔥 The heating element has burned out (a common problem with frequent use).
• 📶 Open circuit (check relay R17 in the block under the hood).
• 💡 Malfunction of the heating button.

Solution: Test the circuit with a multimeter. If the heating element is damaged, replace the mirror glass (sold separately for some models).

3. Glass fogging from the inside

Reasons:

• 💧 Moisture getting inside the case (depressurization).
• 🔥 Heating malfunction (condensate does not evaporate).

Solution: Remove the mirror, dry it with a hairdryer (temperature no higher 60°C) and seal the joints with silicone. If the problem persists, replace the glass.

4. The mirror camera does not transmit an image

Reasons:

• 📺 The data cable is damaged.
• 🔌 Oxidation of contacts in the connector.
• 🖥️ Multimedia system firmware failure.

Solution: Check cable integrity and clean contacts. If the problem is in the firmware, the unit may need to be re-flashed AVM in the service.

⚠️ Attention: If, after replacing the mirror with camera, a message appears on the screen "Camera Error", this may indicate a firmware incompatibility. In this case, adaptation of the camera via a diagnostic scanner is required (for example, Nissan Consult III).

Upgrade: is it possible to install mirrors with a camera on the basic version?

Many owners Qashqai J11 in basic configurations (Visia, Acenta) want to add a 360-degree view function by installing mirrors with cameras. Technically this is possible, but you will need:

1. Buy mirrors with cameras (items 26550-4M02A And 26500-4M02A).
2. Install a multimedia system with support Around View Monitor (For example, NissanConnect with screen 7" or 8").
3. Route the wiring from the mirrors to the control unit AVM (located behind the glove compartment).
4. Flash a block BCM And AVM to recognize new cameras.

The cost of such modernization may exceed 50 000–70 000 ₽, so the feasibility depends on your needs. An alternative is to install a separate rear view camera with image display on a standard screen (will cost 10 000–15 000 ₽).

Where to buy and how much does a replacement cost?

Mirror prices for Nissan Qashqai J11 vary depending on type and manufacturer:

Mirror type	Original (₽)	Analogue (₽)	Service replacement cost (₽)
Mechanical	3 500–4 500	1 800–2 500	1 000–1 500
Electric heated	8 000–12 000	4 000–6 000	1 500–2 000
With camera (Around View)	15 000–20 000	8 000–12 000	2 500–3 500

You can buy mirrors:

• 🛒 Official dealers Nissan - guarantee of original parts, but high price.
• 🌍 Online stores (For example, Exist.ru, Autodoc, Emex) - a wide selection of analogues.
• 🔧 Showdown - a budget option, but there is a risk of buying a worn-out part.

The cost of replacement service depends on the complexity of the work. For example, replacing a mechanical mirror will cost 1 000–1 500 ₽, and installation of a mirror with a camera and wiring - up to 5 000 ₽. If you are confident in your abilities, you can save money by doing the work yourself (see instructions above).

FAQ: Frequently asked questions about mirrors Nissan Qashqai J11

Can the mirror housing be painted to match the body color?

Yes, but to do this you need to remove the mirror and take it to a car service for painting. Use original color code Nissan (For example, KAD for black, QAB for white). Cost of painting - from 3 000 ₽ for one mirror.

Why is the right mirror more foggy than the left?

This is due to the design: the right mirror is located further from the stove blower, so the condensation on it dries longer. The solution is to use heating more often or treat the glass with an anti-fog agent (for example, Sonax Anti-Fog).

How to fold mirrors manually if the electric drive does not work?

Gently pull the mirror towards you - the folding mechanism is usually not blocked. If the mirror does not budge, do not use excessive force to avoid breaking the plastic guides.

Is it possible to install mirrors from Nissan X-Trail T32 on Qashqai J11?

No, despite the external similarity, the fastenings and connectors for these models are different. Mirrors from X-Trail physically won't fit.

What to do if the mirrors stop working after washing?

Most likely, water got into the connectors. Dry them with a hairdryer or compressed air. If the problem persists, check the fuse box - there may be a short circuit.