Cabin filter in Nissan Tiida - this is a detail that many owners remember only when a persistent smell of dust appears in the cabin, and the air conditioner begins to work with effort. Meanwhile, A clogged filter not only degrades air quality, but also creates an additional load on the ventilation system, reducing the life of the stove and air conditioner. In this article we will look at how to correctly select and replace the cabin filter with Tiida (including restyled versions C11 And C13), without contacting the service.
The replacement procedure takes no more than 15 minutes, but requires knowledge of the nuances: from the location of the filter to the features of fastening the plastic panels. We have collected current articles of original filters and proven analogues, and also described in detail the typical mistakes that beginners make. If you have never done anything like this, don’t worry: the instructions are adapted for those who are picking up a screwdriver for the first time.
Where is the cabin filter located in Nissan Tiida?
B Nissan Tiida The cabin filter is located behind the glove compartment on the passenger side. This is a standard solution for most Japanese cars, but there is an important nuance: depending on the year of manufacture and configuration, the mounting location may differ slightly. For example, in pre-restyling versions (2004–2007) access to the filter is a little more difficult due to the different design of the plastic lining.
To get to the filter you need to:
- 🔧 Open the glove compartment and remove all contents.
- 🔍 Press the latches on the sides of the glove compartment (they are located closer to the floor) and lower it down.
- 🚗 Behind the glove compartment you will see a plastic filter cover - it is attached with latches or screws (depending on the modification).
In some trim levels Tiida (for example, with climate control), the filter can be covered with an additional soundproofing panel. It must be carefully bent so as not to damage it.
- Every 10,000 km
- Once a year
- Only when the smell appears
- Never changed
Original filters and analogues: articles and prices
Original cabin filter for Nissan Tiida has an article number 27277-4M000 (coal) or 27277-4M001 (regular dust). The cost of the original in official dealers ranges from 1,200 to 1,800 rubles, but there are proven analogues that will cost less without losing quality.
| Brand | Article | Type | Price, ₽ | Notes |
|---|---|---|---|---|
| Nissan | 27277-4M000 |
Coal | 1 500–1 800 | Original, best quality |
| Mann | CU 22003 |
Coal | 800–1 100 | Optimal price/quality ratio |
| Bosch | 1 987 429 655 |
Coal | 900–1 200 | Good filtration, but a little harsher than the original |
| Filtron | K 1254 |
Dusty | 400–600 | Budget option |
When choosing between coal And dusty filter, take into account the operating conditions:
- 🌆 Coal better suited for the city - it traps not only dust, but also harmful gases (for example, exhaust).
- 🌳 Dusty cheaper and suitable if you drive mostly on the highway or in environmentally friendly areas.
⚠️ Attention: Do not buy filters without packaging or dubious brands. Cheap fakes can disintegrate during use, clogging the ventilation system with debris.
Step-by-step instructions for replacing the cabin filter
To replace the filter you will need:
- 🔧 Flat screwdriver (or plastic clip remover).
- 🧴 Wet wipes or vacuum cleaner (to remove accumulated dirt).
- 📦 New filter (check that it fits correctly).
Sequence of actions:
- Remove the glove compartment. Open it, press the side latches (they are located closer to the floor) and lower the glove compartment down. In some versions Tiida You may need to unscrew 2-3 screws.
- Remove the plastic cover. It is attached with latches - pry it off with a screwdriver or puller. Be careful: plastic is fragile!
- Remove the old filter. It may be pressed by the frame - pull it towards you. Please note arrow direction on the filter (they indicate air flow).
- Clean the seat. Use a vacuum cleaner or cloth to remove accumulated dirt, leaves and dust.
- Install a new filter. Follow the direction of the arrows - they should be looking down (in the direction of air movement).
- Reassemble everything in reverse order. Make sure that the filter cover is seated tightly and that the glove compartment is not loose.
☑️ What to check after replacement
If after replacement there is still a smell in the interior, the problem may be in air conditioner evaporator - it needs to be cleaned with a special spray (for example, Liqui Moly Klima-Anlagen-Reiniger).
What to do if the filter does not fit into place?
If the new filter does not fit, check:
- Correctness of the model (sometimes they sell filters for Tiida C13 instead of C11).
- The presence of a sealing frame (some analogues do not have it).
- Cleanliness of the seat (garbage can get in the way).
If the problem remains, compare the old and new filters in size (should match down to a millimeter).
Typical replacement mistakes and how to avoid them
Even such a simple procedure as replacing the cabin filter can result in problems if the nuances are not taken into account. Here are the most common mistakes:
- Incorrect filter direction. Arrows on the filter indicate the direction of air flow. If you put it “back to front”, the filtration efficiency will drop by 30–40%.
- Damage to plastic clips. Many owners Tiida they break the glove box or filter cover latches when trying to open them with a screwdriver. Use a plastic puller or wrap a screwdriver with electrical tape.
- Ignoring seat cleaning. If you do not remove the accumulated dirt, the new filter will clog 2-3 times faster.
- Buying a filter that is the wrong size. For example, a filter from Nissan Note looks similar, but may not fit Tiida.
⚠️ Attention: If, after replacing the filter, the stove begins to blow weaker, check to see if debris has gotten into the ventilation ducts. Sometimes, if the replacement is not done carefully, leaves or dust penetrate deeper, clogging the heater radiator.
Another common problem is glove compartment creaking after assembly. This means that you have not latched the latches correctly. Solution: Remove the glove compartment again and check that all the latches are in place.
When to change the cabin filter: signs and regulations
The manufacturer recommends changing the cabin filter at Nissan Tiida every 15,000 km or once a year. However, in real operating conditions (especially in large cities), this interval should be reduced to 10,000 km.
Signs that it is time to change the filter:
- 🌬️ The draft of the stove or air conditioner has worsened (even at maximum fan speed the air flows weakly).
- 🤧 A persistent smell of dust or mold appeared in the salon.
- 🚗 The glass began to fog up more often than usual.
- 🔍 Visually, the filter is gray or black (the new one should be white or light gray).
If you often drive on dusty roads or sit in traffic jams, check the condition of the filter every 5,000 km. To do this, it is not necessary to remove it - just shine a flashlight through the air intake grille (it is located under the windshield).
Before replacing the filter, turn on the stove at maximum power and blow out the ventilation system for 1–2 minutes. This will help remove dust accumulated in the channels.
What is the difference between replacing Tiida C11 and C13?
Although Nissan Tiida first (C11, 2004–2010) and second (C13, 2010–2016) generations are similar in appearance, their cabin filter design is slightly different:
| Parameter | Tiida C11 (2004–2010) | Tiida C13 (2010–2016) |
|---|---|---|
| Filter location | Behind the glove compartment, under the plastic cover | Behind the glove compartment, but the lid can be secured with screws |
| Glove compartment mounting type | Only on latches | Latches + 1–2 self-tapping screws (in some configurations) |
| Filter size | 200×190×20 mm | 205×195×20 mm (sometimes different) |
| Availability of coal option | Yes, but less common | Yes, more widespread |
B Tiida C13 with climate control, you may need to remove an additional panel (it blocks access to the filter). To do this you need:
- Unscrew the 2 screws under the glove compartment.
- Carefully pry off the bottom part of the panel (it goes all the way to the floor).
- After replacing the filter, reassemble everything in reverse order.
If you are not sure about your model, check the car's VIN or compare a photo of the filter seat on the Internet.
Is it possible to drive without a cabin filter?
Technically Nissan Tiida will drive without a cabin filter, but this will lead to several problems:
- 🚗 Accelerated wear of the stove and air conditioner. Dust and debris will settle on the radiator, reducing its heat output.
- 🤧 Deterioration of health. Unfiltered air from the street will enter the cabin, containing harmful particles (especially dangerous for allergy sufferers).
- 💨 Fogging of glass. The filter also regulates air humidity - without it, the glass will sweat more often.
If the filter has become unusable and you don’t have a new one at hand, you can temporarily drive without it, but not longer 1–2 weeks. As a last resort, install at least the cheapest dust filter - it's better than nothing.
⚠️ Attention: In some cases, the absence of a filter may result in stove fan failure. Dust falling on the blades creates an imbalance, causing the motor to fail.
FAQ: Frequently asked questions about replacing the Tiida cabin filter
Is it possible to wash the old filter instead of replacing it?
Technically, you can wash the filter (for example, vacuum it or rinse it with water), but this is a temporary solution. After washing, the filter loses up to 60% of its effectiveness, as the pores become clogged with dirt forever. Better to spend money on a new one.
Which filter is better: carbon or regular?
A carbon filter is better at trapping harmful gases and odors, but is more expensive and can clog faster. A regular dust one is cheaper and is suitable if you drive mostly outside the city. For the city we definitely recommend coal.
What should I do if there is still a smell after replacing the filter?
Most likely, the problem is in the air conditioner evaporator - mold accumulates there. You need to treat it with a special cleaner (for example, Step Up or Liqui Moly) through the drain hole under the machine.
Is it possible to replace the filter without removing the glove compartment?
Theoretically it is possible, but it is very inconvenient. Without removing the glove compartment, you will not be able to properly clean the seat and risk damaging the plastic parts. It's better to spend 2 minutes dismantling.
Will a filter from a Nissan Note work?
No, filters from Note And Tiida different in size. U Note the filter is narrower and shorter. Always check the item number before purchasing.