Reset Nissan Note: Complete Guide for All Generations

Reset settings Nissan Note to factory parameters - a procedure that sooner or later every owner of this compact hatchback encounters. Whether it’s preparing for sale, eliminating software glitches after unsuccessful tuning, or dealing with “glitches” of a multimedia system - a correct reset can save thousands of rubles on diagnostics. But here lies the catch: incorrect actions lead to blocking of the immobilizer, loss of key binding, or even failure of the control unit.

In this article we will look at all types of resets for Nissan Note (including models E11 2004-2012 and E12 2012-2020), from a simple system restart to a complete ECU reset. You will learn how to avoid common reset mistakes (for example, why the engine may not start after resetting), what tools you will need to restore the climate control to work, and how to save the radio settings before resetting. We will pay special attention error codesthat appear after an incorrect reset, and how to eliminate them without visiting the service.

Types of reset on Nissan Note: which one to choose?

Before you begin the procedure, it is important to determine what kind of reset your car requires. Not only the algorithm of actions, but also potential risks depend on this. On Nissan Note There are three main types of reset available:

• 🔄 Soft reset — restart of electronic systems without loss of user data. Suitable for eliminating temporary failures of multimedia or climate control.
• 🧹 Hard reset — complete reset of settings to factory settings, including resetting ECU errors, but maintaining key binding.
• 🔧 ECU reset — deep zeroing, affecting engine and transmission adaptations. Requires special equipment or scanner.

In practice, owners Note E12 (2012+) more often face the need hard reset after unsuccessful multimedia system firmware NissanConnect or malfunction of the rear view camera. For older models E11 more relevant ECU reset, especially if the car was operated on gas or after chip tuning. The mistake of many is trying to do hard reset by disconnecting the battery, which Nissan Note with immobilizer NAT-2 leads to engine starting blocking.

Which reset do you need? Answer the questions:

Preparing for a reset: what you need to do in advance

Unprepared reset to Nissan Note can lead to troubles - from the loss of saved radio stations to the inability to start the car. Here is a checklist of required actions before the procedure:

Pay special attention unlock codes. On Nissan Note E12 with the system NissanConnect After the reset, you may need to enter a PIN code for the radio (usually located on a sticker in the glove compartment or in the service book). If the code is lost, it can be restored using the VIN through an official dealer (paid service, ~1500 rubles). For models with climate control Automatic A/C after the reset, the dampers will need to be retrained - the procedure takes up to 20 minutes and is described in the section Self-Diagnosis service manual.

⚠️ Attention: On vehicles with the system Nissan Intelligent Key (keyless entry) after a hard reset, the keys may need to be reprogrammed. Without original scanner CONSULT-III or its analogue (for example, Launch X431) it is impossible to do this - you will have to go to the service center.

If you are planning a reset due to an error P0300 (multiple misfires) or P0171 (lean mixture), check first:

• 🔋 Battery condition (voltage below 12V will lead to incorrect ECU reset).
• 🛢️ Fuel level (less than 1/4 tank may cause fuel system errors after reset).
• 🔌 Connected devices (disconnect DVRs, radar detectors and cigarette lighter chargers).

Soft reset: reboot the system without losing data

Soft reset - the safest way to “reboot” electronic systems Nissan Note without consequences. It helps in 80% of cases of temporary failures: freezing of the multimedia screen, incorrect operation of parking sensors or climate control glitches. The procedure takes less than a minute and does not require tools.

Algorithm for Nissan Note E11/E12:

1. Turn off the ignition and remove the key from the lock.
2. Open the driver's door (important to reset the access system).
3. Press and hold the door lock button on the key (or on the panel) for 10 seconds.
4. Return the key to the ignition switch, turn to position ON (do not start the engine).
5. Wait 30 seconds - the system will perform a self-test (all indicators on the dashboard may flash).
6. Turn off the ignition, wait 10 seconds and start the engine.

For models with NissanConnect (2013+) there is an alternative way:

1. Нажмите и удерживайте кнопки "Volume -" и "Tune +" на панели магнитолы одновременно.
2. Удерживайте 15 секунд до появления логотипа Nissan на экране.
3. Отпустите кнопки — система перезагрузится (займёт ~2 минуты).

If after soft reset the problem persists (for example, the rear view camera does not turn on or the parking sensors beep constantly), this indicates a hardware failure or need hard reset. In the case of a multimedia system NissanConnect A common error after a reboot is getting stuck on the logo. Solution:

What should I do if NissanConnect gets stuck on the logo?

This indicates firmware corruption. You will need to flash it via USB with the official software (the file "NissanConnect_E12_Update.zip" can be downloaded from the NoteClub forum). The procedure takes ~40 minutes, but requires stable power (it is better to connect an external battery).

Hard reset: full reset to factory settings

Hard reset on Nissan Note — this resets all user settings, including:

• 📻 Saved radio stations and sound settings.
• 🔑 Passwords and PIN codes for Bluetooth and Wi-Fi (if available).
• ⚙️ Individual climate control and lighting settings.
• 🚗 Transmission adaptations (for models with CVT Jatco JF015E).

On models E11 (2004-2012) reset is performed by disconnecting the battery, but this is fraught with problems with the immobilizer. For E12 (2012+) there is a safer way through the service menu:

Instructions for Nissan Note E12:

1. Turn on the ignition (position ON), but do not start the engine.
2. Press and hold the button Trip Reset (daily mileage reset) on the dashboard.
3. Turn the key to position OFF, then back to ONwithout letting go Trip Reset.
4. Hold the button again 10 seconds — the service menu will appear on the display.
5. Using a button Trip Reset select item Initialization (initialization).
6. Confirm your choice by holding the button - the reset process will begin (will take ~3 minutes).

For Nissan Note E11 the procedure is more complicated:

1. Отключите минусовую клемму аккумулятора.
2. Нажмите на педаль тормоза и удерживайте её 20 секунд (разряжает конденсаторы ECU).
3. Подождите 15 минут (это критично для сброса иммобилайзера NAT-2!).
4. Подключите клемму обратно и запустите двигатель.
5. Если двигатель не заводится, выполните процедуру обучения ключей (см. раздел ниже).

⚠️ Attention: On cars with a CVT Jatco JF015E after hard reset transmission adaptation required. To do this:

1. Warm up the engine to operating temperature.
2. Drive 10 km in D mode without sudden acceleration.
3. Stop, turn off the engine for 1 minute, then drive again.

Ignoring this step will result in jerky gear changes.

ECU reset: when a deep reset is required

Resetting the Engine Control Unit (ECU) on Nissan Note - an extreme measure that is resorted to when:

• 🔧 Unsuccessful chip tuning (errors P0605, P0607).
• 🛢️ Switching from gasoline to gas (or vice versa) without adaptation.
• 🚗 Constant errors P0100 (MAF sensor) or P0340 (phase sensor).

On Nissan Note E11 with engines HR15DE or HR16DE ECU reset is performed via diagnostic connector OBD-II using a scanner (for example, ELM327 with the program Nissan DataScan). An alternative method is a manual reset:

Manual ECU reset (for advanced users):

1. Remove the fuse box cover under the hood (driver's side).
2. Remove the fuse ECU-IG (number F30, 10A) for 10 minutes.
3. Disconnect the negative battery terminal for 5 minutes.
4. Connect everything back and start the engine.
5. Let it idle for 10 minutes - the ECU will perform self-learning.

For Nissan Note E12 with the system Eco Mode After resetting the ECU, additional throttle calibration will be required. This can be done through the hidden menu:

1. Включите зажигание (ON).
2. В течение 5 секунд нажмите педаль газа до упора 5 раз.
3. Выключите зажигание, подождите 10 секунд.
4. Запустите двигатель — ECU запишет новые параметры заслонки.

On models with a CVT, after resetting the ECU, be sure to adapt the transmission through a scanner (the "CVT Fluid Deterioration Data Reset" procedure). Without this, the variator will operate in emergency mode with a speed limit of up to 4000 rpm.

Errors after reset: how to fix?

Even if the reset is performed correctly Nissan Note New errors may appear. Here are the most common ones and how to fix them:

Error code	Reason	Solution
U1000	Loss of communication with the CAN bus (often after disconnecting the battery)	Reboot all electronic modules: disconnect battery for 1 hour
B210E	Immobilizer error (key not recognized)	Follow the key learning procedure (see section below)
P0507	Incorrect idle speed after ECU reset	Perform throttle learning (instructions above)
C1130	ABS malfunction (appears after hard reset)	Drive 5 km at a speed above 40 km/h to self-test the system
U1010	Mismatch between ECU and immobilizer data	The ECU requires flashing at the service level (cannot be fixed on its own)

If after reset it lights up Check Engine with code P0300 (misfire), this is normal - the ECU “forgot” to adapt. To resolve:

1. Fill up a full tank of fuel (at least 95 gasoline).
2. Drive 50 km in mixed mode (city + highway).
3. Avoid sudden acceleration and braking.

For immobilizer errors (B210E, B2192) on Nissan Note E11 perform key training:

1. Вставьте первый ключ в замок зажигания.
2. Поверните в положение ON на 5 секунд, затем OFF.
3. Повторите шаг 2 для второго ключа.
4. Вставьте первый ключ снова, поверните в ON — индикатор иммобилайзера должен погаснуть.

Recovery after a reset: settings and adaptations

After any reset to Nissan Note systems need to be reconfigured. Here's what you need to do first:

• 📡 NissanConnect: Enter your PIN (if required), search for radio stations, and sync Bluetooth.
• ❄️ Climate control: Start automatic calibration (hold the button AUTO 10 seconds).
• 🔑 Immobilizer: Carry out key training (instructions above).
• 🚘 CVT: Perform adaptation (if there are jerks during acceleration).

For models with Around View Monitor (360° cameras) the system will need to be calibrated after a reset. This can only be done through a scanner CONSULT-III or its equivalent. Self-calibration is not possible - if you try manually, the system will give an error C1A10.

If after the reset the lighting settings are lost (for example, automatic headlights), they can be restored through the hidden menu:

1. Включите зажигание (ON).
2. Нажмите и удерживайте кнопку сброса суточного пробега.
3. Поверните переключатель света в положение AUTO.
4. Отпустите кнопку — появится меню настроек освещения.
5. Кнопками управления круиз-контролем выберите нужные параметры.

For owners Nissan Note E12 with the system ProPILOT (adaptive cruise control) after reset the radar will need to be retrained. This can only be done in the service using CONSULT-III Plus. Attempts to calibrate on your own will result in an error. C1A80.

Frequently asked questions about resetting Nissan Note

Is it possible to reset by disconnecting the battery?

On Nissan Note E11 - yes, but this is fraught with problems with the immobilizer NAT-2. On E12 it is better to use the service menu (see section Hard reset). Disabling the battery on models with NissanConnect may result in loss of your navigation chart license.

After the reset, the radio does not work - what should I do?

Most likely, a PIN code is required. If the code is lost, it can be restored using the VIN through a dealer or using a code generator (for example, Nissan Radio Code Generator). For systems NissanConnect Re-flashing may be required.

The reset cleared up the P0300, but a day later it returned. What is the reason?

Error P0300 (misfire) is often associated with faulty ignition coils or spark plugs. Resetting the ECU temporarily masks the problem, but does not fix it. Check the compression in the cylinders and the condition of the high-voltage wires.

Do I need to undergo maintenance or diagnostics after a reset?

If the reset was performed to eliminate software errors (for example, U1000), no diagnostics required. But if the reason for the reset was engine errors (P0171, P0300), it is recommended to check the fuel system and ignition.

Is it possible to reset a Nissan Note with gas equipment?

It is possible, but after resetting the ECU, the LPG will need to be reconfigured. Without adaptation, the engine will operate unstably on gas. Contact the HBO installation center to adjust the injection maps.