Wiper wiper sizes for Nissan Juke 2011: table, selection and replacement

Replacing wipers with Nissan Juke 2011 is a task that every owner faces sooner or later. Worn blades not only impair visibility in the rain, but can also damage the glass, leaving micro-scratches. However, before purchasing new wipers, it is important to know their exact dimensions: unsuitable blades will either not cover the entire area of ​​the glass or will cling to the frames.

In this article we will look at official wiper sizes for Nissan Juke 2011 model year, including front and rear brushes, as well as selection nuances depending on the configuration. You will learn which brands offer the best analogues, how to avoid mistakes when replacing and what to do if standard sizes do not fit. For convenience, we have collected the data in a table and added practical advice from auto experts.

Official wiper sizes for Nissan Juke 2011

Manufacturer Nissan sets to Juke 2011 wipers in the following sizes:

• 🚗 Driver's side front wiper: 600 mm (24 in)
• 🚗 Passenger side front wiper: 400 mm (16 inches)
• 🚗 Rear wiper: 300 mm (12 inches)

These parameters are valid for all trim levels Juke 2011, including basic versions and top-end modifications with additional options. However, it is important to take into account that there are brushes on the market with minor deviations (±10 mm), which will also be suitable if the fastening matches.

Wiper position	Size(mm)	Size (inches)	Mounting type
Front (driver)	600	24	Hook
Front (passenger)	400	16	Hook
Rear	300	12	Top Lock

Pay attention to the type of mounting: front wipers Juke use standard Hook (hook), and the back one - Top Lock (latch). This is critical when choosing analogues, since even if the size matches, an incompatible mount will make the brush unusable.

How to check the size of the wipers on your Juke

If you are unsure of the dimensions or suspect that the previous owner installed non-original brushes, you can measure them yourself. To do this:

1. Remove the wiper from the glass by pressing the fastening lock.
2. Place the brush on a flat surface and measure its length from edge to edge using a tape measure or ruler.
3. Compare your data with the table above.

It's important to measure namely the working part of the brushexcluding the plastic end caps. Also check the markings on the back of the wiper - many manufacturers indicate the size directly on the product.

Which wipers to choose: original or analogues

Owners Nissan Juke Often faced with a dilemma: buy original brushes or analogues from third-party brands. Let's look at the pros and cons of each option.

Original Nissan wipers

• ✅ Perfect Compatibility: guaranteed to fit in size and mounting.
• ✅ Quality of materials: The rubber bands of the original brushes retain their elasticity longer.
• ❌ Price: 2–3 times more expensive than analogues (from 1,500 to 3,000 rubles per set).
• ❌ Availability: Not always in stock, especially for the rear wiper.

Analogues from third-party brands

Among the analogues the following stand out:

• 🏆 Bosch Aerotwin: Frameless brushes with an aerodynamic profile, suitable for high speeds.
• 💎 Valeo Silencio X-TRM: premium segment, reduce noise by 20% compared to standard ones.
• 💰 SWF Visioflex: a budget option with a good price/quality ratio (from 600 rubles per set).
• 🔧 Champion EasyVision: universal brushes with adapters for different types of fastenings.

When choosing analogues, be sure to check mount compatibility. For example, wipers Bosch often come with a universal adapter that needs to be installed correctly.

How to spot a fake Bosch?

Original Bosch brushes have:

- Logo on the fastening clip (not a sticker!)

- Serial number on the back

- Packaging with a hologram and barcode, which can be checked on the manufacturer’s website.

Typical mistakes when replacing wipers

Even experienced drivers sometimes make mistakes that lead to windshield wipers breaking or glass damage. Here are the most common of them:

⚠️ Attention: Never turn on your wipers if they are frozen to the glass! This may bend the arms or tear off the rubber. In cold weather, first use a defroster or warm water (not boiling water!).

• 🔧 Incorrect fastening: trying to install a brush with a mount Top Lock to the front wiper (where needed Hook) will cause the latch to break.
• 📏 Size mismatch: a brush with a length of 650 mm instead of 600 mm will cling to the windshield frame during operation.
• 🧹 Ignoring cleanup: If you do not clean the glass and rubber band from sand before installation, the new wipers will last 2 times less.
• 🔩 Tightening the nuts: when replacing wiper arms (for example, after an accident), excessive tightening force may deform the threads.

Another common problem is buying wipers with inappropriate profile. For example, winter brushes with a cover are not intended for summer use: they adhere less well to the glass and wear out faster in the heat.

Make sure the new brushes are the right size and fit.

Clean the windshield from dirt and sand

Check the mobility of the wiper arms (if there is any play)

Lubricate the lever joints with silicone grease (if necessary)-->

How to extend the life of your wipers

The average service life of brushes is 6–12 months, but with proper care they can be used for up to 2 years. Here's what will help keep your wipers in working order:

• 💧 Regular cleaning: Once a month, wipe the rubber bands with a damp cloth and soapy water to remove grease and microparticles.
• ❄️ Winter preparation: Before frost, treat the rubber band with silicone grease (for example, WD-40 Specialist) to prevent freezing.
• 🚿 Correct Use: Do not turn on the wipers on dry glass - this will wear off the rubber. First, wet the glass with washer.
• 🔧 Pressure check: If the brushes do not fit well, adjust the tension of the arms (but do not overdo it!).

Also avoid car washes with aggressive chemicals - alkaline shampoos destroy the rubber of the wipers. After washing, rinse the brushes with clean water.

What to do if standard sizes don't fit

In rare cases, the wiper sizes vary Nissan Juke 2011 may differ from standard. This happens for three reasons:

1. The car was restyled or modified (for example, a panoramic windshield was installed).
2. The previous owner installed non-original wiper arms.
3. Manufacturer error (occurs in early batches) Juke).

If your wipers do not match the table, proceed as follows:

1. Remove the brush and measure its length (as described above).
2. Check the car's VIN through the service Nissan or base ETISto clarify the contents.
3. Contact your authorized dealer to request a database check - your model may require special brushes.

For example, for Juke with option "Panoramic Roof" Sometimes front wipers with a length of 550 mm and 380 mm are installed. In this case, the selection is carried out individually.

FAQ: Frequently asked questions about 2011 Nissan Juke windshield wipers

Can you install frameless wipers on the Juke?

Yes, frameless brushes (for example, Bosch Aerotwin or Valeo Silencio) compatible with Nissan Juke 2011. They cope better with wind loads at high speeds, but may not clear as well in heavy icing conditions. The main thing is to choose the right size and mounting adapter.

How often should wipers be changed?

The recommended replacement interval is every 6–12 months. However, if you notice the following signs, replace your brushes sooner:

• The appearance of streaks or streaks on the glass.
• Creaking or knocking noise during operation.
• Detachment of the rubber band from the frame.
• Deterioration of cleaning (drops of water remain).

In regions with frequent rainfall or sandstorms, wipers wear out faster.

What to do if the wipers start “bouncing”?

Bouncing brushes is usually caused by:

1. Rubber band wear — replace the wipers.
2. Glass contamination - clean it of wax or silicone coatings.
3. Loosening of levers - tighten the nuts (but don’t overdo it!).
4. Deformation of levers - the leashes will need to be replaced.

If the problem persists, check the angle of the wipers: they should contact the glass evenly along their entire length.

Is it possible to paint wiper arms?

Yes, but with reservations:

• Use only elastic paints (For example, Plasti Dip or Rust-Oleum Flexidip), which will not crack when the levers move.
• Before painting, remove the arms and clean them of any old coating.
• Do not paint hinges or attachment points as this may impair mobility.

Please be aware that painting may void your arm warranty (if it is still in effect).

Where to buy original wipers for Juke?

Original brushes Nissan can be purchased:

• U official dealers (quality guarantee, but high price).
• In online spare parts stores (Exist.ru, Autodoc, Emex).
• On Avito or Yule (cheaper, but there is a risk of running into a fake).

Article numbers of original wipers for Juke 2011:

• Front driver: 28560-JM00A
• Front passenger: 28561-JM00A
• Rear: 28530-JM00A

Before purchasing, check compatibility using the VIN code.