Nissan Almera is a popular sedan known for its reliability and unpretentiousness. However, even in such a machine, electrical problems periodically arise, and most often the culprit is blown fuses. If your headlights, windshield wipers or cigarette lighter are not working, these are the first things to check.

In this article we will look at where the fuse boxes are located in different generations Almera (including G15, N16 And B10), how to check and replace them correctly, and also provide detailed diagrams with a decoding of each element. You will learn which fuses are responsible for the key components of the car and how to avoid common mistakes when replacing them.

Where are the fuse boxes in Nissan Almera?

Depending on generation and configuration Nissan Almera may have one or two fuse blocks. Their main locations:

  • 🔧 Main unit — located in the cabin, under the instrument panel on the driver’s side. Usually closed with a plastic lid with latches.
  • 🚗 Additional block — located in the engine compartment, next to the battery (typical for Almera G15 And N16).
  • ⚡ Relay block - often combined with the main fuse box or located next to it.

B Almera Classic (B10) The main fuse box is hidden behind the glove compartment - to access it, just remove the side panel. In newer models (G15) the block has been moved closer to the steering wheel, under the decorative trim.

Important: before searching for a block, turn off the ignition and remove the negative terminal from the battery - this will protect you from a short circuit if you accidentally touch the contacts.

📊 What generation of Nissan Almera do you have?
  • Almera G15 (2012–2019)
  • Almera N16 (2000–2006)
  • Almera Classic B10 (2005–2012)
  • Other

Fuse diagram Nissan Almera G15 (2012–2019)

Model Almera G15 - one of the most common on the Russian market. It uses two fuse blocks: cabin and engine compartment. Below is the transcript salon unit, which is responsible for the majority of consumers.

Fuse no. Denomination (A) Purpose
F1 10 Body Control Module (BCM), Immobilizer
F2 10 Audio system, navigation
F3 15 Cigarette lighter, 12V socket
F7 20 Windshield wipers, windshield washer
F10 10 Low beam (left headlight)

The complete diagram can be found in instruction manual your car. Please note: on some trim levels Almera G15 fuse F3 (cigarette lighter) may be on 20A instead of 15A - it depends on the year of manufacture.

Important: fuse F22 (30A) is responsible for the operation of the engine ECU. Its burnout may make it impossible to start the car.

What should I do if the fuse blows again?

If the fuse blows again after replacement, this indicates short circuit in the chain. In this case it is necessary:

1. Check the wiring for damage (especially in kinks).

2. Inspect the consumer that protects this fuse (for example, a windshield wiper motor or headlight bulb).

3. If the problem is not found, contact an auto electrician for diagnostics with a multimeter.

How to check the fuse in Nissan Almera

Checking the fuse is a simple procedure that does not require special skills. You will need:

  • 🔦 Flashlight (for inspecting the block in a dark place).
  • 🛠️ Tweezers or a special puller (often included with the machine).
  • 🔍 Magnifying glass (optional, for inspecting small parts).

Verification algorithm:

  1. Open the fuse box cover (usually it is secured with latches).
  2. Find the required fuse according to the diagram (the number is indicated on the block cover).
  3. Remove the fuse with tweezers and hold it up to the light. Blown fuse will have a broken thread inside or a melted body.
  4. If everything is visually in order, check the fuse with a multimeter in test mode.

Do not use the “old-fashioned method” with a light bulb or wire to check - this may lead to damage to electronics car.

Ignition off

Negative terminal removed from battery

The fuse is selected according to its nominal value (not higher!)

Tool (tweezers) at hand

-->

Replacing the fuse: step-by-step instructions

If you find a blown fuse, you can replace it yourself. Main rule: never use a fuse with a rating higher than specified - this can lead to a fire in the wiring.

Step by step instructions:

  1. Buy a new fuse same denomination. Focus on color: e.g. 10A - red, 15A - blue, 20A - yellow.
  2. Turn off the power (remove the terminal from the battery or turn off the ignition).
  3. Remove the old fuse with tweezers.
  4. Install the new fuse until it clicks.
  5. Check the operation of the circuit (for example, turn on the headlights or cigarette lighter).

If after replacement the fuse blows again - do not repeat the procedure. This indicates a serious fault in the circuit and further action may damage the electronics.

💡

Keep spare fuses of different ratings in the glove compartment. On the road, this will save time if the cigarette lighter or lighting suddenly fails.

Common problems and their causes

Some fuses in Nissan Almera burn out more often than others. Here are the most typical cases:

  • ⚡ Cigarette lighter (F3) — burns out due to the use of powerful devices (for example, car vacuum cleaners or compressors). Solution: Use a fused power strip or connect devices directly to the battery.
  • 💡 Low/high beam (F10, F11) - A common cause is burnt out lamps or moisture getting into the headlight. Before replacing the fuse, check the condition of the lamps and the tightness of the headlight.
  • 🚿 Windshield wipers (F7) — if the fuse blows when the wipers are turned on, check the washer motor and the integrity of the wiring under the hood.

Another common problem is contact oxidation in the fuse block. This leads to poor contact and spontaneous disconnection of consumers. Solution: Clean the contacts with alcohol or a special electronics liquid.

⚠️ Attention: If after replacing the fuse F22 (Engine ECU) the car does not start, check the integrity of the wiring from the fuse box to the ECU. There may be a short circuit.

Fuses in Nissan Almera N16 and Classic B10

In older models (N16 And B10) the fuse diagram is different. For example, in Almera N16 The fuse box is located to the left of the steering column, and in Classic B10 - behind the glove compartment.

Some key fuses for N16:

  • 🔋 F1 (10A) — immobilizer, alarm system.
  • 🎵 F5 (15A) — audio system, antenna.
  • 🔦 F10 (10A) — side lights (right side).

B Almera Classic B10 fuse often fails F8 (20A), responsible for the heater fan. If the stove stops working, check it first.

For accurate fuse identification, always check with sticker on the unit cover - it contains the current diagram for your configuration.

💡

In older models (N16, B10), fuses may be marked differently. Always use the diagram indicated on the block cover, and not universal tables from the Internet.

FAQ: Frequently asked questions

Is it possible to replace the fuse with a more powerful one?

No! Installing a fuse with a rating higher than the rated value may result in fire in the wiring. If the standard fuse constantly blows, look for the cause (short circuit or faulty consumer).

Where to buy fuses for Nissan Almera?

Fuses of standard ratings (10A, 15A, 20A) are sold at any auto store or gas station. For rare ratings (for example, 5A or 30A), it is better to contact specialized auto parts stores.

What to do if the fuse is intact, but the device does not work?

Check:

  1. Integrity of wiring from the fuse box to the consumer.
  2. Relay performance (if it is in the circuit).
  3. The consumer itself (for example, a lamp or motor).

If the problem is not found, contact an auto electrician for diagnosis.

Which fuse controls the radio?

B Almera G15 this is a fuse F2 (10A). B N16 — F5 (15A). If the radio does not work after replacement, also check the fuse in its own power supply (usually located at the back of the device).