<em>Nissan Juke</em>cigarette lighter fuse: where is it located, diagram and how to replace

Nissan Juke - a compact crossover with a bright design, but even in it the electrical circuits sometimes fail. One of the most common problems is a blown cigarette lighter fuse (or 12V outlet). This happens when connecting powerful devices (compressors, inverters), short circuits or worn contacts. If the cigarette lighter stops working, do not rush to go to a service center: in 90% of cases the fault is the fuse, which you can replace yourself in 5 minutes.

In this article you will find the exact location of the cigarette lighter fuse for Nissan Juke first (J10, 2010–2014) and second (J11, 2014–2019) generations, fuse ratings, step-by-step replacement instructions and diagnostic tips. We will also look at why the fuse may re-blow and how to avoid it.

Where is the cigarette lighter fuse located? Nissan Juke: block diagram

B Nissan Juke The cigarette lighter fuse is located in interior fuse box (inside the car). Its location depends on the generation and configuration, but the general principle is the same. Below are diagrams for both versions of the crossover.

For Juke J10 (2010–2014) fuse box is located under the glove compartment on the driver's side. To gain access, just open the cover (it is secured with latches). For Juke J11 (2014–2019) block moved into the niche under the steering wheel, next to the brake pedal - its cover is marked with the symbol FUSE.

The fuse you are looking for is usually designated as:

• 🔌 CIGAR (for cigarette lighter)
• ⚡ PWR OUTLET (for 12V socket)
• 🔋 ACC SOCKET (in some trim levels)

Fuse rating - 15A or 20A (depending on the year of manufacture and sales market). In European versions it is often 15A, in American and Japanese - 20A. Never install a fuse of a higher rating! This may cause a wiring fire.

Fuse box diagram: where to look CIGAR or PWR OUTLET

To avoid confusing the cigarette lighter fuse with others, refer to the diagram. Below are the current wiring for both generations Juke.

Generation	Fuse designation	Denomination (A)	Location in the block	Additional circuits on this fuse
Juke J10 (2010–2014)	F30 (CIGAR)	15	3rd row, 4th from left	12V socket in trunk (if equipped)
Juke J11 (2014–2019, Europe)	F22 (PWR OUTLET)	20	2nd row, 5th from left	USB port (on some trims)
Juke J11 (2014–2019, USA/Japan)	F25 (ACC SOCKET)	15	3rd row, 2nd from left	Glove compartment lighting

If there is no diagram on the block cover, take a photo of it before removing it. As a last resort, focus on the color of the fuse:

• 🟢 15A - green
• 🟡 20A - yellow
• 🔴 25A - red (not suitable for cigarette lighter!)

⚠️ Attention: In some versions Juke with the system NissanConnect The cigarette lighter fuse may be connected to the multimedia unit. If the radio stops working after replacing the fuse, check the circuit AUDIO in the fuse block.

Step-by-step instructions: how to replace the cigarette lighter fuse

Replacing a fuse is a simple procedure, but requires care. Follow the instructions to avoid damaging the unit or contacts.

Step 1: Turn off the power. Remove the key from the ignition and open the driver's door. This will break the circuit and prevent a short circuit when replacing.

Step 2: Locate the fuse box.

• For J10: Press the lid latches under the glove compartment and pull it down.
• For J11: open the cover in the niche under the steering wheel (it is marked FUSE).

Step 3: Remove the old fuse. Use tweezers (usually attached to the block cover) or pliers. Carefully pry the fuse and pull it out. Do not use force! If the fuse is stuck, rock it from side to side.

Step 4: Check the fuse. Inspect it under the light: if the metal thread inside is burned out, the fuse must be replaced. You can also check with a multimeter in “continuity” mode - a working fuse should show a resistance of ~0 Ohm.

Step 5: Install a new fuse. Insert a fuse of the same rating (15A or 20A) into the socket until it clicks. Make sure it fits snugly and doesn't wobble.

Step 6. Check the operation of the cigarette lighter. Turn on the ignition and check the 12V socket with a tester or connect a device (for example, a phone charger). If the fuse blows again, there is a short circuit in the circuit (see the section “Why does the fuse burn again”).

Why the cigarette lighter fuse lights up repeatedly: 5 reasons and solutions

If a new fuse blows immediately or this happens regularly, the problem lies not in it, but in the circuit. Here are the most common causes and ways to eliminate them:

1. Short circuit in the socket. The most common culprit is metal contacts that oxidize or become deformed over time. Solution: disassemble the socket, clean the contacts with sandpaper or replace it entirely (part number for Juke — 285B0-JM00A).
2. Connecting powerful devices. Compressors, inverters or refrigerators may exceed the load capacity (maximum per socket Juke - 120–150 W). Solution: Use a fused power strip or connect devices directly to the battery.
3. Damaged wiring. Frayed or melted wires behind the socket can short out the housing. Solution: inspect the wiring harness behind the cigarette lighter (remove the center tunnel trim). If the insulation is damaged, insulate or replace the wire.
4. USB port problem. B Juke J11 The 12V socket is sometimes combined with a USB connector. If the port is shorted, it may blow the fuse. Solution: Disconnect the USB cable from the multimedia system and check the fuse.
5. Battery problems. Voltage surges (for example, when “lighting” from another car) can damage the circuit. Solution: Check the battery voltage with a multimeter (should be 12.6–14.4V).

⚠️ Attention: If the fuse blows immediately after replacement, do not install a fuse of a higher rating (for example, 25A instead of 15A). This may cause the outlet to melt or the wiring to catch fire. Instead, unplug the outlet (remove the terminal from the battery) and diagnose the circuit with a multimeter.

How to check a circuit with a multimeter?

Set the multimeter to dial mode (Ω). Unplug the outlet (remove the fuse). Connect the probes to the socket contacts: if the resistance is ~0 Ohm, the circuit is closed. If it shows "OL" (open), the problem is in the fuse or wiring.

Common mistakes when replacing a fuse: what not to do

Even something as simple as replacing a fuse can turn into problems if mistakes are made. That's what absolutely cannot be done:

• 🔥 Use bugs. Replacing a fuse with a wire or foil is a direct path to a fire. The fuse is designed for a specific load, and its absence can melt the outlet or wiring.
• ⚡ Install a fuse of a different rating. For example, 20A instead of 15A. This will increase the risk of the circuit overheating. If a fuse blows frequently, look for the cause rather than increasing its rating.
• 🔧 Use force when removing the fuse. If it does not come out, do not try to pull it out with pliers - this may damage the socket. Use tweezers or WD-40 to clean the contacts.
• 🚗 Ignore the check after replacement. Always test the outlet before connecting devices. If a fuse has blown due to a short circuit, reconnecting the load may blow it out again.

Another common mistake is do not check related circuits. For example, in Nissan Juke The cigarette lighter fuse is sometimes connected to the glove compartment light or USB port. If these elements stop working after replacing the fuse, check the circuit ILLUM or USB POWER in the block.

How to extend the life of a cigarette lighter fuse: 5 tips

To avoid frequent fuse replacement, follow these guidelines:

1. Use quality devices. Cheap chargers or compressors often cause current surges. Buy certified accessories with overload protection.
2. Do not overload the outlet. Maximum power per outlet Juke — 120–150 W (10–12.5A). If you connect multiple devices, use a splitter with its own fuse.
3. Clean contacts regularly. Oxidation or dirt in the socket increases resistance and heat. Clean the contacts every six months with alcohol or a special spray (for example, Kontakt 60).
4. Avoid moisture. If liquid (coffee, water) gets into the socket, immediately turn off the fuse and dry it with a hairdryer. Moisture causes corrosion and short circuits.
5. Check the wiring. Periodically inspect the wiring harness behind the outlet for chafing or melting. This is especially true for cars with high mileage.

If you frequently plug in high-power devices (such as a refrigerator), consider installing an additional outlet with a separate fuse. This will reduce the load on the standard chain and extend its life.

FAQ: Frequently asked questions about the cigarette lighter fuse Nissan Juke

Is it possible to replace the cigarette lighter fuse with a higher rating (for example, 25A)?

No! It's dangerous. The fuse is rated for the maximum current that the wiring can handle. Installing a 25A fuse instead of a 15A fuse may result in a melted socket or even a fire. If a fuse blows frequently, look for the cause (short circuit, overload) instead of increasing the rating.

Where to buy a fuse for the cigarette lighter Juke?

Fuses of standard ratings (15A, 20A) are sold at any auto store or gas station. For Nissan Juke Suitable fuses: ATO/ATC (flat, knife). You can buy a set of fuses of different ratings (costs 100–300 rubles). Original fuses Nissan (article 28500-4M000) are no different from universal ones, but are more expensive.

The cigarette lighter stopped working, but the fuse is intact. What's the matter?

If the fuse is good, the problem may be:

• 🔌 The outlet itself (oxidized or burnt contacts).
• 🔋 Wiring (break or short circuit).
• 📱 Multimedia system (in J11 the socket is sometimes connected to NissanConnect).

Check the voltage at the socket contacts with a multimeter (should be ~12V). If there is no voltage, look for a break in the wiring.

Is it possible to change the cigarette lighter socket yourself? Juke?

Yes, it's not difficult. You will need:

• New socket (item number for J10 — 285B0-JM00A, for J11 — 285B1-JM01A).
• Flat-head screwdriver for removing cladding.
• Tweezers or pliers.

Disconnect the battery, remove the center tunnel trim, disconnect the socket connector and install a new one. Detailed instructions are available on YouTube (search for "Nissan Juke cigar socket replacement").

After replacing the fuse, the radio stopped working. What to do?

In some trim levels Juke The cigarette lighter fuse is connected to the multimedia system. If after replacement the radio stops working:

1. Check the fuse AUDIO or NAVI in the block.
2. Reset the radio settings (disconnect the battery for 5 minutes).
3. If the problem persists, the fuse in the radio itself may have blown (it will need to be disassembled).