Cigarette lighter fuse <em>Nissan Teana J32</em>: location, replacement and typical faults

Nissan Teana J32 (2008–2013) is a reliable business-class sedan, but even it occasionally experiences electrical problems. One of the most common is a failure of the cigarette lighter or 12V socket. In 90% of cases the burnt out is to blame fuse, not the connector itself. However, not everyone manages to find it the first time: in Teana J32 The fuse box is hidden in a non-obvious way, and the diagrams in the manual are often not detailed enough.

This article will help you understand which fuse is for the cigarette lighter? in your Nissan Teana J32, where exactly it is located (in the cabin or under the hood), how to properly check and replace it. We will also look at hidden reasons for frequent blown fuses, which are not described in the official documentation, and we will give recommendations on choosing a replacement. If after reading you still have questions, at the end of the article there is an FAQ with answers to typical situations.

Where is the cigarette lighter fuse located? Nissan Teana J32?

B Teana J32 responsible for the cigarette lighter (and 12V socket in the trunk, if there is one) fuse #30 face value 15A. It is located in internal fuse box, which is hidden behind the glove compartment on the passenger side. Important: in some trim levels (for example, with an audio system Bose) the scheme may differ - more on that below.

To get to the block:

• 🔧 Open the glove compartment and remove all contents from it.
• 🔍 Press the latches on the sides of the glove compartment and pull it towards you - it will be removed from the guides.
• 🔌 Behind the glove compartment you will see a black plastic fuse box cover. There is a diagram on it.
• 📄 The cigarette lighter fuse is marked as CIGAR or PWR OUTLET (depending on the year of manufacture).

If your car has a 12V socket in the trunk, it may be connected to a separate fuse №31 (also 15A). You can check this using the diagram on the back of the unit cover or using a multimeter.

⚠️ Attention: On models with audio system Bose The cigarette lighter fuse is sometimes combined with the amplifier fuse. If the music stops working after replacing the fuse, check the fuse №17 (10A) in the same block.

What fuse is needed to replace?

For Nissan Teana J32 fits standard fuse type ATO (or ATM) face value 15A. It is important to use this particular rating - installing a fuse with a large amperage (for example, 20A) can lead to fire in the wiring!

Characteristics of the original fuse:

Parameter	Meaning
Type	ATO/ATM (knife)
Denomination	15A (red or blue)
Size	19 × 5 × 18.5 mm
Case color	Red (standard for 15A)
Article (for ordering)	28500-4M000 (Nissan original) or any equivalent (for example, Bosch, Hella)

Where to buy:

• 🛒 In any auto store (cost - from 20 to 100 rubles).
• 🌍 On Wildberries, Ozon or AliExpress (sets of 10 pieces from 150 rubles).
• 🚗 At gas stations with auto stores (usually universal kits are sold).

⚠️ Attention: Do not use "bugs" (homemade wire jumpers) instead of a fuse! This may lead to short circuit and wiring fire. B Teana J32 The cigarette lighter wires go directly to the battery - the risk is very high!

Step-by-step instructions for replacing the fuse

Replacing the cigarette lighter fuse in Nissan Teana J32 takes no more than 5 minutes. You will need:

• 🔧 Flat screwdriver (for removing the glove compartment).
• 🔍 Flashlight (to see the block better).
• 🔌 New 15A fuse.
• 📱 Multimeter (optional, for checking).

Next follow the instructions:

1. Turn off the power. Remove the key from the ignition and make sure that all electrical consumers (headlights, radio) are turned off.
2. Remove the glove compartment. Press the side latches and pull it towards you. It will come off without effort.
3. Find fuse #30. There is a diagram on the block cover. The cigarette lighter fuse is usually labeled as CIGAR or PWR OUTLET.
4. Remove the old fuse. Use plastic tweezers (included in the unit) or small pliers. Pay attention to the condition of the contacts - if they are melted, the problem may be in the wiring.
5. Install a new fuse. Insert it until it clicks. Make sure the rating is the same (15A).
6. Check the operation of the cigarette lighter. Turn on the ignition and try connecting a device (for example, a phone charger).

Why does the cigarette lighter fuse often blow?

If a fuse blows immediately after replacement or after a short time, the reason lies not in the fuse itself, but in circuit malfunction. B Nissan Teana J32 most common reasons:

• ⚡ Short circuit in the socket. Debris has entered, liquid or contacts have shorted due to wear. Often the culprit is coins or paper clips falling into the slot.
• 🔌 The connected device is faulty. Cheap chargers, compressors or inverters can produce current surges. For example, a non-original DVR with a bad power supply.
• 🔋 Wiring problems. The wire from the cigarette lighter to the fuse box is frayed or melted. B Teana J32 The wires go under the dashboard - they could have been damaged when installing the alarm.
• 🎵 Conflict with the audio system. In cars with Bose The cigarette lighter fuse is sometimes connected to the amplifier. If the music plays with distortion, check the amplifier.

How to diagnose:

1. Disconnect all devices from the cigarette lighter and replace the fuse. If it does not burn out, the problem is in one of the gadgets.
2. Shine a flashlight into the cigarette lighter socket. If you see foreign objects or traces of oxidation, clean the contacts.
3. Test the wiring with a multimeter. Disconnect the negative terminal of the battery, remove the cigarette lighter connector and check the resistance between the positive wire and ground. If it is close to zero, look for a short circuit.

What should I do if the fuse blows immediately after replacement?

Most likely the problem is a short circuit. Do not install a new fuse - instead, unplug the cigarette lighter connector (it is secured with two bolts under the dash) and check the circuit with a multimeter. If the fuse does not blow without the cigarette lighter, replace the connector itself (part number: 28535-4M000).

How to check a fuse without a multimeter?

If you don't have a tester at hand, you can check the fuse visually or using a simple light bulb. Methods:

• 👁️ Visual inspection. Take out the fuse and look at the light: if the thread inside is burned out (broken), it needs to be replaced. Attention: sometimes the break is not visible to the naked eye!
• 💡 Check with a light bulb. Take any 12V light bulb (for example, from the dimensions) and two wires. Connect one wire to ground, and the second one alternately to the two fuse contacts. If the light does not light up on any of the contacts, the fuse has blown.
• 🔄 Replace with a known working one. Instead of the suspicious fuse, replace it with another one with the same rating (for example, from a radio). If the cigarette lighter worked, the problem was in the fuse.

If the fuse is intact but the cigarette lighter does not work, check:

• 🔌 The connector itself. It happens that the contacts inside the cigarette lighter have oxidized or become bent. Try gently bending them with a screwdriver.
• 🔋 Power on the connector. When the ignition is turned on, the voltage at the central contact should be ~12V (checked with a light bulb or multimeter).
• 🔧 Relay. In rare cases, the relay is to blame POWER OUTLET (if it is included in your package). It is located in the same block as the fuses.

Common mistakes when replacing a fuse

Even something as simple as replacing a fuse can be done incorrectly. Here are the typical mistakes of owners Nissan Teana J32:

• 🔥 Using a fuse of the wrong rating. For example, setting 20A instead of 15A. This creates a risk of fire, especially if a powerful device (such as a compressor) is plugged into the outlet.
• 🔧 Incomplete removal of the old fuse. Sometimes the contacts remain closed and the new fuse immediately blows. Always make sure the old fuse is completely removed.
• 💦 Working under voltage. Many people forget to turn off the ignition before replacing. This is dangerous: you can short out the contacts or get an electric shock (even a weak one).
• 🔍 Ignoring the cause of burnout. If a fuse is blown, simply replacing it is not enough. You need to find the cause (short circuit, faulty device) and eliminate it.

How to avoid mistakes:

• Always check the fuse rating twice (on the body and according to the diagram).
• Use the plastic tweezers from the fuse box - it prevents the contacts from shorting.
• If the fuse blows again, do not install a new one, but look for the cause (see section above).

Alternative ways to connect devices when the cigarette lighter is not working

If the fuse constantly blows and repair of the cigarette lighter is postponed, you can temporarily connect the devices in other ways. Options for Nissan Teana J32:

• 🔌 Socket in the trunk. If it is included in your configuration, check fuse No. 31 (15A). Usually it is connected separately.
• 🚗 Direct connection to battery. Suitable for powerful devices (compressors, refrigerators). Use a fused wire (eg 10A for compressor). Minus: when the engine is turned off, the battery drains quickly.
• 🔋 USB connectors. B Teana J32 since 2011, there are USB ports (5V) in the central tunnel. Suitable for charging phones, but not for powerful devices.
• 🔧 Installing an additional outlet. You can run a new wire from the fuse box (for example, from the radio fuse) and install the connector in a convenient location. Important: use safety lock no more than 10A for a new socket.

Warnings:

• Do not connect devices with more power 120W (10A) to USB or standard sockets - this will lead to overload.
• When connecting directly to the battery, be sure to use a fuse on the positive wire (maximum 50 cm from the terminal).
• Do not leave devices connected overnight as this may drain the battery.

FAQ: Frequently asked questions about the cigarette lighter fuse in Nissan Teana J32

Can I use a 20A fuse instead of a 15A fuse?

No! The 15A fuse is installed for a reason - it protects the wiring from overload. B Teana J32 The cigarette lighter wires are designed for current up to 15A. If you supply 20A, if there is a short circuit, the wires may melt or catch fire. If your device requires more current (for example, an inverter), connect it directly to the battery through a separate fuse.

After replacing the fuse, the radio does not work. What to do?

In your car, the cigarette lighter fuse is combined with the audio system fuse (especially if you have Bose). Check the fuse №17 (10A) in the same block. If it is burnt out, replace it. If the problem persists, contact an electrician - the amplifier or wiring may be faulty.

Which fuse is for the socket in the trunk?

In most trim levels Nissan Teana J32 The socket in the trunk is connected to a separate fuse №31 (15A) in the same block (behind the glove compartment). If you don't have a diagram, check the fuses one by one with a multimeter or a light bulb.

Is it possible to repair a cigarette lighter if it does not secure the plugs?

Yes, often the problem is in straightened contacts. Remove the cigarette lighter (it is secured with two bolts under the decorative trim), disassemble it and carefully bend the metal “antennae” inside the connector. If the housing has melted, it is better to replace the entire cigarette lighter (part number: 28535-4M000).

Where can I find a fuse diagram for my configuration?

The diagram is located on the back of the fuse box cover (behind the glove compartment). If it is erased, download the instruction manual for your year of manufacture on the website Nissan Global (section Owners → Manuals). For Teana J32 2008–2013 the circuits are almost identical, but may differ in versions with Bose.