Nissan Terrano 3: location and assignment of fuses (2014–2023)

Nissan Terrano 3 (also known as Renault Duster in some countries) is a compact crossover that has gained popularity due to its reliability and unpretentiousness. However, even in such a car, problems with electrical equipment periodically arise - from non-working headlights to cigarette lighter failure. In 90% of cases, the culprit is burnt out fuses or faulty relay.

If you are faced with the fact that some electrical device in your Terrano 3 stopped functioning, the first step is to check the corresponding fuse. But where are they? How to replace them correctly? And what to do if after replacement the problem does not go away? In this article you will find detailed fuse box diagrams, their decoding, as well as step-by-step instructions for diagnostics and repair.

Where are the fuse boxes in Nissan Terrano 3

B Nissan Terrano 3 (years 2014–2023) provided two main fuse boxes:

• 🔧 Main unit in the cabin — located to the left of the steering column, behind the protective cover. The fuses and relays responsible for most car systems (lighting, audio system, power windows, etc.) are concentrated here.
• 🚗 Additional block under the hood — located next to the battery, in a plastic box. High power fuses are located here (for example, for cooling fan, ABS, starter).

Also in some configurations may be present third block - it is usually hidden behind the glove compartment or under the center console and is responsible for the multimedia system or climate control. However, in basic versions Terrano 3 he is often not there.

To gain access to the interior unit, just pull the cover towards you (it is secured with latches). In the engine compartment, the cover is attached to two plastic clips - they need to be carefully snapped off with a screwdriver.

Diagram and decoding of fuses in the cabin block

Salon block Nissan Terrano 3 contains fuses and relays responsible for the main comfort and safety systems. Below is detailed table with the purpose of each element (valid for most trim levels 2014–2023).

Number	Ampere	Purpose	Notes
F1	10A	Side light bulbs (left side)	Also responsible for the license plate illumination
F5	15A	Low beam (right headlight)	If burnt out, check the lamp and contacts
F10	20A	Cigarette lighter/socket 12V	Often fails when connecting powerful devices
F15	10A	Audio system, navigation	May burn out if there is a short circuit in the speakers
F20	25A	Window lifters (all)	When the mechanism jams, the fuse burns out instantly

A complete diagram with photographs can be found in instruction manual your car (section "Electrical equipment"). If the manual is not at hand, download it electronically from the official website Nissan or on thematic forums (for example, terrano-club.ru).

⚠️ Attention: fuse F30 (30A) responsible for the work Engine ECU. Replacing it with the ignition on can lead to reset of adaptations and unstable operation of the engine. Always disconnect the battery before tampering with this fuse!

Underhood fuse box: what is located there

In the engine compartment Nissan Terrano 3 are power fuses, which protect circuits with high current consumption. Relays that control the operation of key systems are also located here:

• ⚡ Starter fuse (usually 50–80A) - if it fails, the engine will not start.
• 💨 Cooling fan fuse (40A) - if it burns out, the engine will overheat.
• 🔋 Generator fuse (100–120A) - if it malfunctions, the battery does not charge.
• 🚨 ABS relay — is responsible for the operation of the anti-lock brake system.

Features of the engine compartment - fuses here often “sit” very tightly. To remove them, it is recommended to use special tweezers (usually included with the car) or pliers with insulated handles.

If you find that the fuse in this block has blown, don't rush to replace it. First, check the circuit for a short circuit - often the cause is damaged wiring or a faulty consumer (for example, a failed cooling fan).

How to properly replace a fuse in a Nissan Terrano 3

Replacing a fuse is a simple procedure, but there are some nuances here too. Follow these instructions to avoid mistakes:

1. Turn off the ignition and remove the terminal from the battery (especially important for the engine compartment).
2. Find the faulty fuse. Typically, a burnt-out element has a broken thread inside or a melted body.
3. Remove it with tweezers. Do not use metal objects (screwdrivers, knives) under any circumstances - this may damage the contacts of the unit.
4. Install a new fuse the same denomination. Using a high ampere fuse may cause a fire!
5. Check circuit operation. If the fuse blows again, look for a short circuit.

If after replacement the fuse burns out again, this means that there is short circuit. In this case it is necessary:

• 🔍 Check the wiring for exposed wires or melted insulation.
• 💡 Disconnect consumers connected to this circuit (for example, a radio or additional equipment).
• 🛠️ Contact an auto electrician if you were unable to find the problem yourself.

Common problems with fuses in Terrano 3 and their solutions

Owners Nissan Terrano 3 often encounter typical faults related to fuses. Here are the most common ones:

1. The cigarette lighter fuse (F10, 20A) is constantly on.

The reason usually lies in:

• 🔌 Connecting powerful devices (for example, a compressor or refrigerator) without using an adapter.
• 🔥 Short circuit in the outlet itself (often due to moisture or metal objects).

Solution: Replace the cigarette lighter socket or use a fused power strip.

2. The power window fuse blows (F20, 25A)

This happens due to:

• ❄️ Jamming of the window lift mechanism (especially in cold weather).
• 🔧 Wear of guides or cable.

Solution: Lubricate the mechanism with silicone grease or replace the faulty motor.

3. Low beam does not work (fuses F5/F6, 15A)

If the fuses are intact but the light does not come on, check:

• 💡 The lamps themselves (often burn out at the same time).
• 🔌 Contacts in the headlight unit (oxidation or corrosion).
• 📱 Low beam relay (located in the cabin unit).

⚠️ Attention: If in your Terrano 3 installed xenon headlights, never replace fuses in their circuit without disconnecting the ignition unit! High voltage (up to 25,000 V) can cause serious electric shock.

Where to buy fuses for Nissan Terrano 3

Fuses for Nissan Terrano 3 They are sold in any auto store, but not all of them are the same in quality. Here's what you need to know when purchasing:

• 🏷️ Original fuses from Nissan (article 28510-JD00A for typing) - the most reliable, but also expensive.
• 🔧 Analogues from Bosch, Hella or Vibe — good price/quality ratio.
• ❌ Cheap "no-name" fuses - often have poor-quality contacts and can cause a fire.

The cost of one fuse varies from 10 to 100 rubles, depending on the denomination and brand. A set of 20–30 fuses of different ratings will cost 300–800 rubles.

When purchasing, pay attention to:

• 🔢 Denomination (must exactly match the requirements of the circuit).
• 🔌 Housing type (in Terrano 3 fuses are used mini blade).
• 📏 Size (standard - 10x38 mm, but there are also miniature options).

If you are not sure about your choice, take it with you blown fuse as a sample - the seller will help you choose an analogue.

How to distinguish a quality fuse from a fake?

A high-quality fuse has a clear rating marking, smooth contacts without burrs and a body made of heat-resistant plastic. Counterfeits often have dull color, jagged edges and can melt at the slightest stress.

FAQ: Frequently asked questions about fuses in Nissan Terrano 3

Is it possible to temporarily replace the fuse with a bug (wire)?

No, this is extremely dangerous! The "bug" has no protective properties and can lead to car fire. If you urgently need to get to the repair site, use a fuse with same denomination, even if it temporarily does not fit (you can bend the contacts).

Why did all the devices stop working after replacing the fuse?

Most likely you installed a fuse wrong denomination or the battery terminals are connected incorrectly. Check:

• Compliance of fuse amperes with circuit requirements.
• Polarity when connecting the battery (plus to plus, minus to minus).
• The presence of other blown fuses (sometimes a whole group fails).

How to check a fuse without removing it from the block?

Can be used multimeter in call mode:

1. Install the probes on the fuse contacts.
2. If there is a sound signal, the fuse is intact.
3. If there is no signal, the fuse has blown.

You can also visually inspect the fuse through light - if the thread inside is broken, it needs to be replaced.

Which fuses are most likely to blow in Terrano 3?

According to owner statistics, the following most often fail:

1. F10 (20A) - cigarette lighter.
2. F20 (25A) - window lifters.
3. F5/F6 (15A) - low beam.
4. F15 (10A) - audio system (especially when connecting a subwoofer).

Do I need to change the relay if it gets hot?

Yes, relay heating is a sign malfunctions. This may be caused by:

• Wear of contacts inside the relay.
• Increased load on the chain.
• Short circuit.

If the relay gets hot, it must be replaced, otherwise it may raft and cause more serious problems.