Nissan Presage: wheel, rim and tire sizes for all generations

Minivan Nissan Presage - one of those cars where the correct selection of wheels directly affects not only comfort, but also safety. This Japanese minivan, produced in 1998–2009, had several modifications with different suspension and body parameters. And if for the owners Qashqai or X-Trail the choice of tires often comes down to standard sizes, then with Presage the situation is more complicated: here it is important to take into account the year of manufacture, the type of drive and even the configuration.

In this article we will look at official wheel sizes for all generations Nissan Presage, including permissible deviations for tuning, the consequences of the wrong choice and the nuances of seasonal tire changes. We will pay special attention disk compatibility — after all, even a minimal discrepancy in the offset (ET) or diameter (PCD) can lead to accelerated wheel bearing wear or steering problems.

Official wheel sizes for Nissan Presage by generation

Nissan Presage produced in two generations: R50 (1998–2003) and R51 (2003–2009). Despite their external similarity, they had different suspension parameters and, as a result, recommended wheel sizes. Below is a table with data from factory manuals and catalogs Nissan.

Generation	Years of manufacture	Tire size (standard)	Disc Diameter (inches)	Rim Width (inches)	Reach (ET, mm)	PCD (bolt pattern)
R50 (1st generation)	1998–2003	205/65 R15	15	6.0J	40–45	5×114.3
R50 (optional)	1998–2003	215/60 R16	16	6.5J	40–45	5×114.3
R51 (2nd generation, basic)	2003–2009	205/60 R16	16	6.5J	40	5×114.3
R51 (optional, 4WD)	2003–2009	215/55 R17	17	7.0J	40	5×114.3

It is important to note that for Presage R51 with all-wheel drive (4WD) wheels of larger diameter were allowed - up to 17 inches, but only if you use tires with a lower profile. This is due to the suspension design and ground clearance restrictions.

⚠️ Attention: Installing discs with offset ET < 35 mm or > 45 mm without modification of the suspension will lead to premature wear of the wheel bearings and deterioration in handling. In some cases, this may cause a refusal of warranty service (if the car is still under warranty).

Tolerable deviations: what can be changed without risk?

Many owners Presage they want to install larger wheels - to improve appearance or handling. But there are strict restrictions that cannot be ignored. Let's look at what parameters you can change without compromising safety:

• 🔄 Disc width: An increase of ±0.5 inches from the standard value is allowed (for example, instead of 6.5J can be supplied 7.0J, but not wider).
• 📏 Tire profile: Can be reduced by 5–10 units when increasing the disc diameter (for example, with 205/60 R16 on 215/55 R17), but The overall outer diameter of the wheel must remain within ±2% of the factory.
• 🔧 Departure (ET): Deviation is allowed within ±5 mm. For example, if the standard departure 40 mm, you can install disks with ET 35–45 mm.
• ⚙️ Bolt Pattern (PCD): Only 5×114.3. The use of adapter rings or adapters is strictly not recommended - this violates the geometry of the suspension.

When choosing custom sizes, be sure to check ground clearance — the wheel should not touch the suspension elements or arches when the steering wheel is fully turned or the car is loaded at maximum. For Presage R51 with a rear multi-link suspension this is especially critical.

How to choose the right tires: seasonal nuances

Selecting tires for Nissan Presage depends not only on the size, but also on the season. There are a few key points here:

• ❄️ Winter tires: It is recommended to use narrow tires with a high profile (e.g. 195/70 R15 instead of 205/65 R15) for better grip on snow. The speed index must be at least T (190 km/h), and the load index corresponds to the maximum vehicle weight (indicated in PT on the sidewall of the tire).
• ☀️ Summer tires: The optimal choice is hard tires with a low profile (for example, 215/55 R17), but only if the road surface in your area is good. For dirt roads it is better to stay on 205/60 R16.
• 🌧️ All-season tires: For Presage this is a compromise option, but only if the temperature in your region in winter does not drop below -10°C. At lower temperatures, the rubber hardens and the braking distance increases by 20–30%.

Pay special attention tire pressure. For Presage recommended values:

• Front wheels: 2.2–2.4 bar (depending on load).
• Rear wheels: 2.4–2.6 bar (at full load up to 2.8 bar).

⚠️ Attention: If you are using tires with a load index lower than the recommended one (e.g. 91T instead of 94H), the risk of a wheel exploding when driving at high speed or with a full load increases by 3–4 times. This is especially true for Presage like a minivan, which is often operated at maximum load.

Common mistakes when choosing wheels and their consequences

Many owners Nissan Presage make critical mistakes when selecting wheels, which lead to expensive repairs. Let's look at the most common of them:

1. Ignoring crash (ET). Installing discs with offset ET 30 mm instead of standard 40 mm moves the wheel outward, increasing the load on the wheel bearing. Consequences: noise when driving, wheel play and bearing replacement after 10–15 thousand km.
2. Bolt pattern mismatch (PCD). Using discs with PCD 5×100 (for example, from Toyota) with adapter rings leads to uneven tightening of bolts and vibrations at higher speeds 80 km/h.
3. Installing tires that are too wide. Wider tires 225 mm on Presage require rolling out the arches, otherwise, when the steering wheel is turned completely, they will rub against the fender liners, which will lead to their destruction.
4. Failure to comply with diameter. Increasing the wheel diameter by more than 1 inch (for example, with R16 on R18) without changing the tire profile will lead to incorrect speedometer readings (error up to 10%) and increasing the load on the transmission.

Another common problem is incorrect bolt tightening torque. For Presage it should be 90–110 Nm. Over-tightening leads to deformation of the brake discs, and insufficient tightening leads to the wheel coming loose while driving.

What happens if you install wheels with the wrong offset?

When installing discs with offset ET < 35 mm the wheel moves outward, resulting in:

- Increased load on the wheel bearing (lifetime is reduced by 2–3 times).

- Changes in suspension geometry, which causes uneven tire wear.

- Risk of the wheel hitting the body elements when the steering wheel is turned completely.

Upon departure ET > 45 mm the wheel “sinks” inward, which can lead to contact with the shock absorber or spring.

How to check wheel compatibility before purchasing?

Before purchasing new wheels for Nissan Presage be sure to follow these steps:

Check the year of manufacture and generation of your Presage (R50 or R51)

Check the bolt pattern (PCD 5×114.3) and center hole diameter (DIA 66.1 mm)

Compare the wheel width and offset with the acceptable values ​​from the table above

Make sure that the overall wheel diameter (tire + rim) does not differ more than 2% from the standard

Check the tire load and speed index (must be no lower than factory recommendations) -->

If you are buying used wheels, pay attention to:

• 🔍 Condition of the stiffeners - cracks or dents indicate strong impacts that could deform the disc.
• 🛠️ Traces of corrosion — rust on the seating surface will cause the wheel to wobble.
• ⚖️ Balancing - even a new disk may require balancing, especially if it is cast.

To check the geometry of the disk, you can use a simple test: place the disk on a flat surface and check the gap between the disk and the surface along the entire perimeter. If the gap exceeds 0.5 mm, the disc is deformed and unusable.

Wheel tuning: what can be done without harming the car?

Many owners Presage want to give their minivan a more aggressive or modern look by tuning the wheels. However, it is important here not to cross the line beyond which problems with controllability and safety begin. Let's consider the valid options:

• 🎨 Painting wheels. You can repaint standard wheels in a different color (for example, black or matte silver), but first they must be cleaned of the old coating and treated with anti-corrosion primer.
• 🔧 Installation of caps. Wheel caps for standard wheels are a budget-friendly way to change the appearance. The main thing is that they are compatible with PCD 5×114.3.
• 🚗 Moderate lift. For Presage R51 with all-wheel drive, you can install spacers under the springs (up to 30 mm), which will allow you to install wheels with a diameter R17 without the risk of getting caught.
• 🔄 Replacement with alloy wheels. Alloy wheels of the same size can be installed, but the weight must be comparable to standard steel ones (no more ±10% from the original).

Strictly not recommended:

• Install disks with PCD, different from 5×114.3 (even with adapters).
• Use tires with a speed index lower T (190 km/h).
• Install wheels with a diameter larger than R17 without modification of suspension.

If you are planning serious tuning (for example, installing R18), be prepared for additional costs for:

• Rolling out or cutting arches.
• Replacing shock absorbers and springs with shortened ones.
• Wheel alignment adjustment (may require adjustable arms).

Where to buy wheels for Nissan Presage: proven options

When purchasing wheels for Presage It is important to choose a reliable seller to avoid counterfeits or low-quality products. Let's look at the main options:

• 🏬 Official dealers Nissan. Here you will receive a guarantee on wheels and tires, but prices are usually 20-30% higher than market prices. Suitable if you need original spare parts.
• 🛒 Specialized online stores. For example, Kolesa-darom.ru, Shina.ru or TyrePlus. You can find a wide selection here at competitive prices, but be sure to check the seller's reviews.
• 🔄 Used markets. On Avito or Drom.ru they often sell wheels from Presage after replacement. The main thing is to carefully check their condition (see checklist above).
• 🏗️ Tire workshops. Many of them offer wheels on credit or in installments, as well as free balancing with purchase.

When choosing tires, pay attention to the following brands that have proven themselves well in Presage:

• For winter: Nokian Hakkapeliitta, Michelin X-Ice, Bridgestone Blizzak.
• For summer: Continental ContiPremiumContact, Yokohama Advan, Goodyear Eagle.
• All-season: Pirelli Cinturato All Season, Hankook Kinergy 4S.

Before purchasing, be sure to check with the seller:

• Is there a warranty on tires/wheels?
• Is it possible to return a product if it doesn’t fit (many stores give 14 days for returns).
• Is balancing and installation included in the price?

FAQ: Frequently asked questions about wheels for Nissan Presage

Is it possible to install Presage R51 wheels on the Presage R50?

Yes, but with reservations. Discs from R51 (For example, R16 or R17) are physically suitable for R50, since the bolt pattern and the center hole match. However, you need to consider:

• On R50 with basic wheel suspension R17 can touch the arches when the steering wheel is turned completely.
• If on R51 the tires were standing 215/55 R17, then on R50 It is better to choose tires with a slightly larger profile (for example, 205/60 R17) to maintain ground clearance.

Be sure to check the gaps before installation!

What is the maximum wheel size that can be installed on the Presage without modifications?

For most modifications Presage without modifications to the suspension and arches, maximum dimensions:

• R50 (1998–2003): 215/55 R17 with disk width 7.0J and departure ET 40 mm.
• R51 (2003–2009, 4WD): 215/50 R18 with disk width 7.5J and departure ET 38 mm, but only on condition that the car is not operated with a full load.

For versions with all-wheel drive (4WD) a slightly larger diameter is allowed due to the increased ground clearance.

What pressure should Presage tires be when fully loaded?

For Nissan Presage Recommended pressure values when fully loaded (7 passengers + luggage):

• Front wheels: 2.6–2.8 bar.
• Rear wheels: 2.8–3.0 bar.

Exceeding these values by more than 0.3 bar reduces comfort and increases wear on the center tread. Underinflated tires (below 2.0 bar) lead to overheating and risk of explosion at high speed.

Is it possible to fit tires with different profiles on the front and rear on the Presage?

Technically this is possible, but highly not recommended. Different tire profiles front and rear result in:

• Uneven grip on the road, especially on wet surfaces.
• Deterioration in controllability when braking (the car may pull to the side).
• Incorrect operation of systems ABS And ESP (if they are installed).

An exception is the temporary installation of a re-roller, but even in this case the speed should not exceed 80 km/h.

How often should I change my Presage tires?

Tire life depends on driving style and operating conditions, but on average:

• Summer tires: 40–50 thousand km or 4–5 seasons.
• Winter tires: 30–40 thousand km or 3–4 seasons (rubber hardens faster).

Signs that it's time to change your tires:

• Remaining tread depth less 4 mm (for winter) or 2 mm (for summer).
• Cracks on the sides.
• Uneven wear (for example, “saw” on the tread).