Nissan Note is a compact and practical hatchback that has earned the love of car owners for its reliability and convenience. However, even such machines have “weak points”, and one of them is rear wiper. Over time, it begins to creak, does not clean the glass well, or stops working altogether. In this article we will look at how to replace the brush or the entire mechanism yourself, which models are better to choose and what to pay attention to during operation.

Rear wiper in Nissan Note (especially in bodies E11 And E12) often fails due to intensive use, low-quality consumables or simple wear and tear. If you notice that the glass remains dirty after the wiper has been working, or you hear extraneous sounds, it’s time to act. Don't delay repairs: poor visibility through the rear window increases the risk of an accident, especially in rain or snow.

Signs of a faulty rear wiper

How to understand that the rear wiper Nissan Note requires attention? Here are the key symptoms:

  • 🔊 Creaking or knocking during operation - a signal about wear of the brush or motor bearings.
  • 💧 Poor glass cleaning: Streaks, drops or streaks remain, even after several passes.
  • 🔄 Uneven movement: The wiper "bounces" or gets stuck in one position.
  • No reaction to turn on - the problem may be in the motor, fuse or wiring.
  • 🌧️ Brush freezing in winter - if the rubber becomes tan and does not adhere to the glass.

If you observe at least one of these signs, do not rush to change the entire mechanism. In 70% of cases it is enough to replace rubber brush or lubricate moving parts. However, if the wiper does not respond to commands from the steering wheel, the problem may lie in fuse F37 (10A) or relay K30 — their location is indicated in the manual of your modification Note.

⚠️ Attention: If the wiper is stuck in a vertical position and it does not return to its original position, do not try to force it by hand. This may damage the gears of the gearbox. First turn off the power (by removing the fuse) and only then inspect the mechanism.

How to choose a rear wiper blade for Nissan Note

The rear wiper blade is a consumable that needs to be changed every 6–12 months (depending on intensity of use). For Nissan Note The following types of brushes are suitable:

Brush type Length (mm) Fastening Recommended Brands
Frameless 280–300 Hook Bosch, Denso, Valeo
Frame 300–320 Bayonet (pin) Trico, Champion
Winter (heated) 280–300 Hook HELLA, Mitsubishi
Hybrid 290–310 Side Pin Rain-X, PIAA

For most modifications Nissan Note (2006–2020) optimal brush length - 300 mm. But before purchasing, be sure to check:

  • 📏 Exact length old brush (measure with a ruler).
  • 🔗 Mounting type: on Note most often used Hook (U-shaped) or Side Pin.
  • 🌡️ Climatic conditions: for regions with frosts below −20°C, it is better to take winter brushes with silicone coating.

Important: graphite coated brushes (e.g. Bosch Aerotwin) last 30% longer than standard ones, but cost 2–3 times more. It is advisable to install them if you drive more than 20,000 km per year.

📊 Which brush do you prefer for your rear wiper?
  • Frameless
  • Frame
  • Winter heated
  • Hybrid
  • I don't know

Step-by-step instructions: how to remove and install the rear wiper on Nissan Note

Replacing the rear wiper blade with Nissan Note takes no more than 10 minutes. You will need:

  • 🔧 Flat screwdriver (for prying latches).
  • 🧤 Gloves (so as not to get your hands dirty).
  • 🧴 Silicone grease (optional, for processing hinges).

Step 1. Preparation

Park the car on a level surface and turn off the ignition. Raise the wiper to the vertical position (if it is not jammed). If the brush does not rise, turn on the wiper for 1-2 seconds and immediately turn it off - it should stop in the upper position.

Step 2. Removing the old brush

Click on plastic latch at the place where the brush is attached to the lever (usually it is located on the side). Pull the brush down while pressing the latch. If the mount Side Pin, you may need to pry it off with a screwdriver.

Check the integrity of the rubber band on the new brush|

Make sure the mounting type is the same as the old one|

Clean the wiper arm from dirt and rust|

Apply silicone grease to the hinges (optional) -->

Step 3. Installing a new brush

Align the new brush mount with the lever and press until it clicks. Make sure it locks in place by pulling it up and down. If the brush is loose, repeat installation.

Step 4. Check

Turn on the ignition and activate the rear wiper. It should move smoothly, without jerking. If you hear squeaking, apply a little silicone grease onto a rubber band.

⚠️ Attention: If, after replacing the brush, the wiper operates jerkily or does not reach the extreme positions, the problem may be worn lever bushings or loose motor mount. In this case, disassembly of the mechanism will be required.

Repairing the rear wiper mechanism: when is it necessary to replace the motor?

If the brush is in order, but the wiper does not work, the reasons may be as follows:

  • Fuse blown (usually F37 at 10A in the block under the steering wheel).
  • 🔌 Contacts have oxidized in the motor connector.
  • ⚙️ Reducer gear wear (a characteristic sign is that the wiper moves slowly or with pauses).
  • 🔋 Motor failure (no response to switching on, a hum is heard, but there is no movement).

For diagnostics:

  1. Remove the plastic trunk trim (it is secured with clips).
  2. Disconnect the motor power connector and check the voltage with a multimeter (should be 12V with the wiper on).
  3. If there is voltage, but the motor does not work, replacement is required.

Cost of a new rear wiper motor for Nissan Note - from 2,500 to 5,000 rubles (original 28550-JM00A). Analogues from Denso or Valeo will cost less (RUB 1,800–3,000), but may last less.

How to check a motor without a multimeter?

Connect the motor directly to the battery (observing polarity). If it works, the problem is in the wiring or fuse. If not, the motor is faulty.

Caring for your rear wiper: how to extend its service life

To the rear wiper Nissan Note lasted longer, follow simple rules:

  • 🚿 Clean your glass regularly - Dirt and sand accelerate tire wear.
  • ❄️ Do not turn on the wiper on frozen glass - this deforms the brush.
  • 🧴 Treat rubber with silicone once every 2-3 months (prevents cracking).
  • 🔧 Check the lever fastening — loose bolts lead to play.

Use in winter special de-icers for glass (for example, Liqui Moly Anti-Ice). Do not pour hot water on the rear window - a sudden temperature change can damage not only the wiper, but also the heated glass.

💡

If the brush begins to “bounce” during operation, try cleaning it from dirt with a soap solution and wiping it with alcohol. This often restores the elasticity of the rubber.

TOP 5 rear wiper blades for Nissan Note (2026 rating)

Based on reviews from owners and tests by independent experts, we have compiled a rating of the best rear wiper blades Nissan Note:

  1. Bosch Aerotwin AR301H — frameless brush with graphite coating. Price: ~800 rub. (best choice for 24/7 operation).
  2. Denso WI-300 — original quality at an affordable price (~600 rubles). Suitable for winter use.
  3. Valeo Silencio X-TRM 300 — silent operation and long service life (~900 rub.).
  4. Trico Ice 30-300 — winter brush with silicone rubber (~1,200 rub.). Ideal for regions with frost.
  5. Rain-X Latitude 300 — hybrid brush with a water-repellent effect (~1,100 rubles).

When choosing, focus on climatic conditions And intensity of use. For example, for urban use in a temperate climate it is enough Bosch Aerotwin, and for harsh winters it is better to take Trico Ice.

💡

Graphite coated brushes (e.g. Bosch Aerotwin) retain elasticity longer and wear out glass less.

Common mistakes when replacing a rear wiper

Even such a simple procedure as replacing a brush can turn into problems if you make mistakes:

  • 🔧 Incorrect length selection - a brush that is too long will cling to the edge of the glass; a brush that is too short will leave uncleaned areas.
  • 🔗 Ignoring Mount Type - for example, trying to install a brush with Hook to the lever with Side Pin.
  • 🧤 Replacement without gloves - grease from your hands shortens the life of the rubber.
  • Lack of verification after installation - if the brush does not fit well, it will creak and clean poorly.

Another common mistake is using WD-40 to lubricate joints. This composition washes out the factory lubricant and leads to corrosion. Use instead silicone grease or Liqui Moly Silicon-Spray.

⚠️ Attention: If, after replacing the blade, the wiper begins to “walk” across the glass (does not return to its original position), most likely the attachment of the lever to the motor has become loose. In this case, you need to tighten the fastening bolt (the key is on 10).

FAQ: questions and answers about the rear wiper Nissan Note

Is it possible to install a brush from another car on Nissan Note?

Yes, but only if it matches length (280–300 mm) and fastening type. For example, brushes from Renault Sandero or Kia Rio often come up. However, the original brushes Nissan (article 28560-JM00A) are guaranteed compatible.

Why does the rear wiper only work in one direction?

This is a sign gear wear or failure of the reverse mechanism in the motor. Try lubricating the gears with silicone grease. If this does not help, the motor must be replaced.

How often should you change the rear wiper blade?

Depends on intensity of use:

  • For daily use - every 6–8 months.
  • For rare use - once every 1–1.5 years.
  • Winter brushes last less (3–6 months) due to aggressive reagents.
Is it possible to repair the rear wiper motor?

In most cases, no - the gearbox and motor brushes are non-separable. However, sometimes it helps:

  • Cleaning contacts from oxidation.
  • Lubrication of gears (if the housing is dismountable).
  • Replacing the fuse or relay.

If the motor hums but does not rotate, it needs to be replaced.

What to do if the rear wiper is frozen and won't move?

Do not force it on! At first:

  1. Start the car and turn on the heated rear window.
  2. Water the glass warm (not hot!) water or deicer.
  3. Gently pry the brush off with a screwdriver if it is stuck to the glass.

After thawing, check if the rubber is deformed.