Oil filter Nissan 1520865F0A - a critical element of the engine lubrication system Nissan, responsible for cleaning engine oil from abrasive particles, wear products and contaminants. This filter is installed on a number of popular models of the brand, including Qashqai, X-Trail And Navaraequipped with gasoline and diesel power units. Not only the service life of the engine depends on the quality of the filter, but also the stability of its operation under extreme conditions - under high loads or in urban operation with frequent traffic jams.
Unlike universal analogues, the original filter 1520865F0A developed taking into account the specifics of oil channels and pressure in the system of specific engines Nissan. Its design includes high-strength steel housing, synthetic filter material with increased dirt holding capacity and a check valve that prevents oil drainage when the engine is stopped. However, there are fakes on the market that can lead to oil starvation and premature wear of parts. In this article we will look at how to identify the original, select a high-quality analogue and correctly perform the replacement.
Technical characteristics of the Nissan filter 1520865F0A
Filter 1520865F0A belongs to the category spin-on (screw-on), which simplifies its installation and dismantling. The main parameters that you should pay attention to when choosing:
- 🔧 Thread type: M20×1.5 - standard metric thread, compatible with most engines Nissan And Renault.
- 📏 Height/diameter: 86 mm × 76 mm (may vary slightly depending on batch).
- 🛢️ Bypass valve response pressure: 1.1–1.3 bar (protects against destruction during cold starts or clogging).
- 🔄 Check valve: silicone, ensures oil retention in the system after the engine is stopped.
A special feature of this filter is the increased area of the filter element - up to 580 cm², which is 20–30% more than many analogues. This allows you to extend the interval between oil changes when using high-quality synthetic compounds. It is important to note that the filter is designed to work with oils with a viscosity of 0W-20 to 10W-40, but it is considered optimal to use with 5W-30 or 5W-40 for most climatic zones of Russia.
- Mineral
- Semi-synthetics
- Synthetics 5W-30/5W-40
- Synthetic 0W-20
- Other
Compatible with Nissan models and other brands
Filter 1520865F0A installed on a wide range of vehicles Nissan, as well as for some models Renault, Dacia and even Mercedes-Benz (as part of cooperation with the alliance Renault-Nissan). Below is a compatibility table indicating the years of manufacture and engine types:
| Car model | Years of manufacture | Engine type | Notes |
|---|---|---|---|
| Nissan Qashqai (J10, J11) | 2007–2021 | 1.5 dCi (K9K), 1.6 (HR16DE), 2.0 (MR20DE) | Also suitable for Qashqai+2 |
| Nissan X-Trail (T31, T32) | 2007–2020 | 2.0 (MR20DE), 2.5 (QR25DE), 1.6 dCi (R9M) | Hybrid versions require verification |
| Nissan Navara (D40) | 2005–2015 | 2.5 dCi (YD25DDTi), 3.0 V6 (VQ30DE) | Not compatible with NP300 (requires 15208-65F0B) |
| Renault Koleos (HY) | 2008–2016 | 2.0 (MR20DE), 2.5 (QR25DE) | Identical to filter for X-Trail T31 |
| Mercedes-Benz Citan (W415) | 2012–present | 1.5 dCi (K9K) | Only for versions with engines Renault |
Before purchasing a filter, it is recommended to check VIN code car or check the catalog Nissan Parts, since in some modifications (for example, Navara NP300 or Pathfinder R52) filters with a different article number can be used. It is also worth considering that for diesel engines YD25 And R9M requires more frequent filter replacement - every 7,500 km instead of the standard 10–15 thousand km.
Mercedes-Benz Compatibility Details
Filter 1520865F0A is installed on Mercedes-Benz Citan and Vito with Renault K9K diesel engines (1.5 dCi) only in versions for the European market. For vehicles with OM607 or OM654 engines, original Mercedes filters are required (e.g. A 000 180 25 03).
How to distinguish an original filter from a fake
Fake oil filters Nissan 1520865F0A often found in online stores and spare parts markets. Their use is fraught with rupture of the housing, clogging of the oil channels or failure of the bypass valve. Here are the key features of the original:
- 🏷️ Packing: branded box Nissan with a hologram, barcode and article number printed with a laser (not printing ink).
- 🔍 Housing: markings are engraved on the original
NISSAN 15208-65F0A(no typos) and brand logo. - 🛠️ Rubber ring: The O-ring should be black in color, with a uniform texture and without burrs.
- 📦 Internal structure: the filter element is made of synthetic material with a metal mesh frame (counterfeits often have a paper filter).
One of the most reliable ways to check is to weigh the filter. Original 1520865F0A weighs about 320–340 grams (fakes are usually 50–100 grams lighter due to the thin metal of the case). It is also worth paying attention to the quality of the carving: on the original it is smooth, without burrs, and has clear edges.
Before purchasing a filter, check it on the official Nissan website using the serial number. To do this, enter the article in the "Checking original spare parts" section or use the Nissan Parts mobile application.
Step-by-step instructions for replacing the oil filter
Replacing the filter 1520865F0A recommended at the same time as changing the engine oil. To work you will need:
- 🔧 Oil filter puller (chain or cup).
- 🛢️ New oil (volume depends on engine model).
- 🔨 Key on
17 mmfor the drain plug. - 🧰 Container for used oil (minimum 5 liters).
Replacement process:
- Warm up the engine to operating temperature (50–60°C) so that the oil becomes less viscous.
- Lift the car on a lift or place it on a viewing hole. Unscrew the drain plug and drain the oil.
- Using a puller, unscrew the old filter (rotate counterclockwise). Be careful - up to 100 ml of oil may leak from the filter.
- Lubricate the rubber ring of the new filter with fresh oil and screw it in by hand until it stops, then tighten it ¾ of a turn.
- Tighten the drain plug, fill in new oil and check the level with a dipstick.
☑️ Preparing to change the oil and filter
After replacement, start the engine for 1–2 minutes and check for oil leaks in the area of the filter and drain plug. If the oil pressure light on the instrument panel does not go off for more than 5 seconds, immediately stop the engine and check the filter installation.
Do not use lever-type (crab) pullers for Nissan filters - they may deform the housing. The best option: a chain puller or cup size 76 mm.
The best analogues of filter 1520865F0A: what to choose?
If the original filter Nissan is not available, you can consider high-quality analogues from trusted brands. It is important that they correspond to the technical parameters of the original: the opening pressure of the bypass valve, the size and material of the filter element. Best options:
- 🥇 Mann Filter W 610/3 — German quality, increased resource (up to 20 thousand km).
- 🥈 Bosch 0 451 103 336 — optimal price/quality ratio, suitable for turbocharged engines.
- 🥉 Mahle OC 205 — high-quality synthetic filter material.
- 🔹 Fram PH7317 - a budget option, but with less dirt holding capacity.
Among domestic manufacturers, it deserves attention Nevsky filter NF-1016, which is certified for use in engines Nissan. However, its service life is lower - the recommended replacement interval is 7–8 thousand km. When choosing an analogue, be sure to check the manufacturers' catalogs, since some filters (for example, Mann W 610/1) are similar in appearance, but have different technical parameters.
- Original Nissan
- Mann
- Bosch
- Mahle
- Fram
- Other
Common replacement errors and their consequences
Incorrect installation or selection of filter can lead to serious engine damage. Let's look at typical mistakes and their consequences:
- Filter reupholstery. Excessive tightening force deforms the rubber ring, which leads to oil leakage. Optimal tightening torque -
18–22 Nm. - Using the filter without lubricating the ring. A dry ring can “stick” to the seat, which will complicate the next replacement and lead to rubber rupture.
- Ignoring oil changes. Installing a new filter in a system with old oil is pointless - contaminants will quickly clog the filter element.
- Using a filter with inappropriate valve pressure. If the valve opens at a pressure below
1.1 bar, unrefined oil will circulate through the system.
After changing the filter and oil, reset the service interval in the on-board computer (if it supports this function). For Nissan Qashqai this is done through the menu Settings → Maintenance → Reset.
Particular attention should be paid to the choice of oil. For example, for turbocharged engines Nissan (For example, MR20DDT in Qashqai J11) oils with approval are required RN0720 or RN0710. Using the wrong oil will accelerate filter wear and may cause the turbine to seize.
Owner reviews and expert opinion
According to owner reviews Nissan X-Trail And Qashqai, original filter 1520865F0A serves on average 15–20 thousand km when using synthetic oil 5W-30. Among the advantages are noted:
- 👍 Easy to install thanks to clear threads.
- 👍 No oil leaks with proper installation.
- 👍 Stable oil pressure even under high loads.
However, there are also criticisms. Some users complain about the high price of the original (from 800 to 1,200 rubles) and recommend analogues Mann or Bosch as a more affordable alternative. Car service experts confirm that the quality of the original filter justifies its cost, especially for engines with a mileage of over 150 thousand km, where maximum wear protection is important.
When purchasing a filter in an online store, ask for a photo of the packaging with a hologram and serial number. This will reduce the risk of receiving a counterfeit.
FAQ: Frequently asked questions
Can filter 1520865F0A be used on Nissan Almera G15?
No, for Almera G15 (with engine HR16DE) filter with article number required 15208-9M50A. Filter 1520865F0A does not match the size and opening pressure of the valve.
How often should I change the oil filter if I don't drive much?
Even with low mileage (less than 10 thousand km per year), it is recommended to replace the filter once every 12 months. The oil oxidizes over time, and the rubber filter seals lose their elasticity.
What happens if you don't change the oil filter?
A clogged filter causes the bypass valve to open and circulate unrefined oil. This accelerates wear on the liners, piston rings and turbine (if equipped). In critical cases it is possible crankshaft scuffing.
Is it possible to wash the oil filter before replacing it?
No, filter washing is not effective. The filter element is made of porous material that cannot be completely cleaned of microparticles. In addition, flushing may damage the check valve.
Is this filter suitable for Nissan Juke with 1.6 engine?
Yes, filter 1520865F0A compatible with Nissan Juke (F15) with petrol engine HR16DE (2010–2019). For diesel K9K filter required 15208-9M50B.