Which oil filter is suitable for Nissan Almera G15: original vs analogues, part numbers and nuances of choice

Introduction: why choosing an oil filter for Almera G15 is not just a formality

Owners Nissan Almera G15 (2012–2022 model years) are often faced with a dilemma: which oil filter to buy so as not to overpay for the brand, but also not to risk the health of the engine HR16DE. At first glance, a filter is a consumable on which you can save money. However wrong choice can lead to oil starvation, accelerated wear of the turbine (if there is one), or even engine jamming due to a check valve that does not hold pressure after stopping the engine.

In this article we will analyze not only the article numbers of original filters and their analogues, but also technical nuances, which are rarely mentioned in reviews: compatibility with oils of different viscosities, features of filters for turbocharged versions (if you have them in your configuration), as well as pitfalls when buying cheap fakes. You will learn how to identify a counterfeit by 3 key features and why even an original Nissan filter may not be the best choice in some cases.

Original oil filters for Nissan Almera G15: part numbers and features

Factory catalog number of the oil filter for Almera G15 with engine HR16DE — 15208-9F60A. This filter is installed on the conveyor and is recommended by dealers. However, it has several modifications that are often confused:

• 🔧 15208-9F60A - standard filter for atmospheric versions (most Almera G15 in Russia).
• 🔥 15208-9F60B — modification with a reinforced check valve (sometimes found in configurations with a turbine, but not relevant for the Almera G15).
• ⚠️ 15208-9F600 - an outdated article that can still be found on sale, but it is not optimized for modern oils 5W-30 And 0W-20.

The main difference between the original filter is high quality filter element paper with impregnation that does not get wet during prolonged use, and metal case, withstands pressure up to 15 bar. However, many owners note that the original overpriced (from 800 to 1200 rubles), and its analogues are often not inferior in characteristics.

⚠️ Attention: If you see an original filter for less than 600 rubles, it is almost certainly a fake. Official Nissan dealers do not sell consumables at this price, even with discounts.

Article	Applicability	Average price (RUB)	Features
15208-9F60A	Standard for HR16DE	800–1200	Optimal for oils 5W-30, 5W-40
15208-9F60B	Reinforced valve (not for Almera G15)	1000–1400	Suitable for turbocharged engines
15208-9F600	Outdated version	500–700	Not recommended for modern oils

The best analogues of oil filters for Almera G15: comparison of brands

If the original filter seems too expensive, there are worthy analogues on the market that often surpass it in quality. The main thing is to choose a trusted manufacturer. Below we compared 5 most popular brands, which are recommended by service station technicians and Almera G15 owners on forums.

• 🇩🇪 Mann Filter W 610/3 — leader in price/quality ratio. Filter element made of cellulose with synthetic fibers, withstands up to 13 bar. Price: 300–450 rub.
• 🇯🇵 JapanParts FO-599S — Japanese analogue with a metal body and a reinforced check valve. Ideal for cold regions. Price: 400–550 rub.
• 🇫🇷 Bosch 0 451 103 316 - European quality, but sometimes you come across fakes. Pay attention to the hologram. Price: 350–500 rub.
• 🇰🇷 SCT SM 101 - Korean budget option with good reviews. Suitable for 5W-30 oils. Price: 200–300 rub.
• 🇺🇸 Framm PH7317 is an American brand, but low-quality smuggled filters are often sold in Russia. Price: 400–600 rub.

Almera G15 is the most popular among owners Mann And JapanParts - they are rarely counterfeited and have stable quality. But with Framm And Bosch you need to be careful: there are a lot of counterfeits on the market, especially in online stores with suspiciously low prices.

How to distinguish a fake Mann W 610/3 filter?

The original has:

- Clear markings on the body (no blurred letters).

- A plastic cover with the Mann logo on rivets (counterfeits often have glue).

- The filter element is yellow (for fakes it is gray or white).

- The packaging has a hologram and a barcode, which can be checked on the manufacturer’s website.

Which filter to choose for different types of oils?

Not all filters work equally well with oils of different viscosities. For example, for synthetic oils 0W-20 or 5W-30 you need a filter with thicker paper so that it does not get wet from aggressive additives. And for semi-synthetics 10W-40 A budget option is also suitable.

Here are the compatibility guidelines:

• 🛢️ Oils 0W-20, 5W-30: Mann W 610/3, JapanParts FO-599S, Bosch 0 451 103 316 (if original).
• 🛢️ Oils 5W-40, 10W-40: SCT SM 101, original 15208-9F60A, Framm PH7317 (only if quality is confirmed).
• ❄️ For cold regions (below -30°C): JapanParts FO-599S (reinforced check valve) or Mann W 610/3.

If you are using oil with extended drain interval (For example, LongLife), then it’s better not to skimp on the filter - take Mann or JapanParts. Cheap filters may not withstand long-term use and begin to leak unfiltered oil after 7–8 thousand km.

Step-by-step instructions for replacing the oil filter on Almera G15

Replacing the oil filter with Nissan Almera G15 - the procedure is simple, but there are several key pointsthat are often missed. For example, many people forget to lubricate the o-ring of a new filter with oil, which can cause it to “stick” or leak.

You will need:

• 🔧 Oil filter puller (better chain or cup 76 mm).
• 🛠️ New filter and oil (4.3 l for a complete change).
• 🧰 Key 14 for the drain plug.
• 🧻 Rags and container for working out (at least 5 l).

Drain the old oil (the plug is turned counterclockwise).

Clean the filter seat from dirt and remnants of the old seal.

Lubricate the rubber ring of the new filter with fresh oil.

Screw the filter by hand until it stops, then tighten it 3/4 of a turn (do not overtighten!).

Fill in new oil, check the level with a dipstick after 5 minutes.-->

Pay special attention to the filter tightening torque. Overstretched filter may burst when starting the engine, and understretched - let it leak. Optimal tightening torque: 18–22 Nm (or by hand all the way + 3/4 turn).

⚠️ Attention: If after replacement the oil pressure light comes on and does not go out for more than 5 seconds, turn off the engine immediately! This may mean that the filter does not allow oil to pass through (defective or incorrect installation).

Common mistakes when choosing and replacing a filter: how to avoid them

Even experienced car owners sometimes make mistakes that reduce engine life. Here TOP-5 misses when working with an oil filter on Almera G15:

1. Buying a filter “by appearance”. Not all filters are threaded M20x1.5 suitable for HR16DE. For example, a filter from Kia Rio can screw in, but its throughput is lower, which will lead to oil starvation.
2. Ignoring the check valve. Cheap filters often have a rubber valve that stiffens in the cold. This leads to dry start engine after overnight parking.
3. Filter reupholstery. Many people tighten the filter by eye, which leads to deformation of the housing or breakage of the threads on the block.
4. Saving on oil. If you fill in expensive synthetic oil, but install a cheap filter, then the entire effect of the oil is reduced to zero - the filter will not cope with cleaning.
5. Late replacement. Even if you drive little, the filter needs to be changed every 10–15 thousand km (or once a year). Over time, the paper in the filter breaks down and it no longer retains particles.

Another common mistake is washing the filter before installation. Some owners think that this way they will remove “factory dust”, but in fact this disrupts the impregnation of the filter element and reduces its service life.

Answers to frequently asked questions about oil filters for Almera G15

Can I install a filter from another Nissan model?

Yes, but only if the article matches. For example, a filter from Nissan Juke (HR16DE) with article number 15208-9F60A will do, but from Nissan Qashqai (MR20DE) - no, since it has a different diameter and thread.

How often should the oil filter be changed?

Nissan's official schedule is every 15 thousand km or once a year. But if you use semi-synthetics or drive in difficult conditions (dust, traffic jams), it is better to reduce the interval to 10 thousand km.

What happens if you install a filter without a check valve?

When you stop the engine, the oil will drain into the sump, and the next time you start it, the engine will run dry for the first few seconds. This accelerates wear camshafts And hydraulic compensators.

Is it possible to use an oil filter from Lada Vesta?

No! Although Vesta with engine HR16DE the same filter in size, its quality is much worse. In particular, it has a weak check valve and less durable paper.

How to check if a filter is fake?

Inspect the packaging (there should be a hologram, barcode, clear printing), check the weight (counterfeits are 20–30% lighter), and look at the filter element - the original one is uniform, without protruding fibers.