How to turn on fog lights on a Nissan Tiida: instructions with photos and diagrams

Fog lights on Nissan Tiida - not just a tuning element, but an important safety tool, especially in poor visibility conditions. However, many owners encounter difficulties when turning it on for the first time: where is the button, why the lamps do not light up, or how to activate the rear PTFs if they are not included in the basic configuration. In this article we will look at all the nuances - from the location of controls to fault diagnosis.

The material is suitable for all generations Tiida (including restyled versions J31 And J32), as well as for models with different types of dashboards. We will pay special attention common mistakes, which lead to blown fuses or failure of relays. If you have never turned on the fog lights on your car, start from the first section. Experienced drivers can jump straight to fault diagnosis.

Where is the fog light button on a Nissan Tiida?

In most trim levels Nissan Tiida fog lights control is placed on left steering column switch (light control lever). However, depending on the year of manufacture and market, the location may differ. For example, in European versions J32 (2011–2016) the button is often duplicated on the center console next to the interior lighting control.

To find the control, follow these steps:

• 🔦 Check the left steering column switch: It should have a turn ring with a fog light icon (usually a yellow symbol with wavy lines).
• 📍 Inspect the center console: in some trim levels the button is located separately (for example, under the climate control temperature regulator).
• 🔧 Look in the glove compartment: in rare cases (for example, after tuning), the button may be moved to a non-standard location.

If you do not find a button, this does not always mean that there are no fog lights. Perhaps they are simply not connected to the on-board network. In this case you will need wiring check.

Step-by-step instructions: how to turn on the front fog lights

Algorithm for activating front PTFs on Nissan Tiida depends on the type of steering column switch. Below is a universal diagram suitable for 90% of models:

1. Turn the ignition key to position ON (the engine may not be started).

2. Make sure side lights or low beam included (fog lights only work with them!).

3. Find the ring with the fog light icon on the left steering column switch (usually it is located under the high/low beam switch ring).

4. Turn the ring clockwise until it clicks. The yellow indicator with the PTF symbol should light up on the dashboard.

If after these steps the fog lights do not light up:

• 💡 Check the lamps: They often burn out due to power surges.
• 🔌 Inspect the fuse (usually F37 or F38 at 10A in the block under the steering wheel).
• 🔧 Make sure the relay is working properly (located in the same block, marking R17).

Important: on some versions Tiida (for example, for the Japanese market) the fog lights are only activated when low beam on. Dimensions may not be enough!

How to turn on the rear fog lights

Rear fog lights on Nissan Tiida They are less common than the front ones and are usually installed in complete sets Comfort And Tekna. Their inclusion has its own characteristics:

1. Turn on ignition (position ON).

2. Activate side lights or low beam.

3. Find the button with the rear PTF icon on the center console (usually it is located next to the heated rear window button and has a red indicator).

4. Press the button - the dashboard should light up red indicator with a fog symbol.

If there is no button, but the connector for the rear PTF lamp is present (check under the bumper), then your equipment does not include rear fog lights. In this case, you can modify the electrics yourself or contact a service center.

What to do if there is no rear PTF button?

If your configuration does not have a button, but there is a connector for a lamp, you can install the rear fog lights yourself. To do this you will need:

1. Purchase a PTF kit with wiring (for example, from Nissan Note - they fit the connectors).

2. Connect the wires to the fuse box (use the diagram for your model).

3. Install the control button (you can take it from disassembly or order a new one).

4. Check operation using a multimeter.

Attention: Incorrect connection may cause short circuit!

Common mistakes and how to avoid them

Many owners Nissan Tiida make typical mistakes when turning on the fog lights, which lead to breakdowns. Here are the most common of them:

Error	Consequences	How to avoid
Turning on PTF without clearance/low beam	Lamps do not work, wiring may overheat	Always include dimensions first
Long-term operation of PTF without movement	Overheating of the headlight glass and melting of the plastic	Use fog lights only when driving or in fog.
Using PTF instead of low beam at night	Fine for violating traffic rules (Article 12.20 of the Administrative Code)	Fog lights are an addition to the main light, not a replacement
Ignoring the panel indicator	Invisible lamp failure	Watch for the lit PTF symbol on the dashboard

Critical error: connecting fog lights directly to the battery without a fuse. This leads to a fire in 80% of cases!

⚠️ Attention: if, after turning on the PTF, the indicator on the dashboard flashes CHECK ENGINE, immediately turn off the fog lights and check the circuit for a short circuit. This may indicate damaged wiring or a faulty light control unit.

Troubleshooting: why fog lights don't work

If after all the manipulations the fog lights do not turn on, the reasons may be the following (from simple to complex):

1. Lamp burned out. Check the integrity of the filament (at Tiida usually there are lamps H11 or H8).

2. The fuse has failed. For front PTF this is F37 (10A), for the rear - F38 (10A).

3. Relay faulty. Check relay R17 in the fuse box (can be temporarily replaced with a known working one, for example, from a cooling fan).

4. Contacts have oxidized. Often the problem lies in the connectors on the lamps or the light control unit.

5. Broken wiring. Check the circuit from the fuse box to the lamps using a multimeter.

6. The steering column switch is faulty. The contacts inside the switch wear out over time.

For diagnostics, use the following diagram:

1. Проверьте лампы → 2. Проверьте предохранители → 3. Проверьте реле →
4. Прозвоните проводку → 5. Проверьте подрулевой переключатель

⚠️ Attention: If you hear a relay click when you turn on the PTF, but the lamps do not light up, the problem is most likely in the wiring or the lamps themselves. If there is no click, the relay is faulty or there is no power to it.

Modernization: installation of fog lights, if they are not included in the package

If your Nissan Tiida is not equipped with fog lights from the factory, you can install them yourself. To do this you will need:

• 🔧 PTF kit (suitable in size and mounting, for example, from Nissan Note or Micra).
• 🔌 Wiring with connectors (you can take it from disassembly or buy a universal kit).
• 📋 Connection diagram for your model (found in the manual or on owner forums).
• 🔨 Tools: screwdrivers, soldering iron, electrical tape, multimeter.

Step by step instructions:

1. Remove the front bumper (or the part of it where the headlights will be installed).

2. Attach the PTF to the standard places (if they are not there, drill holes and install fasteners).

3. Connect the wires to the lamps, observing the polarity.

4. Route the wiring from the lamps to the fuse box (use corrugation to protect against moisture).

5. Connect the wires to the fuse and relay (connection diagram shown below).

6. Install a control button (if it is not there, you can connect the PTF to the dimensions via an additional relay).

7. Check operation with a multimeter before final assembly.

Connection diagram (simplified):

[Лампа ПТФ] → [Предохранитель 10A] → [Реле] → [Кнопка] → [Блок предохранителей (питание +12V)]

Tips for using and caring for fog lights

To keep the fog lights on Nissan Tiida served for a long time, follow these recommendations:

• 💧 Clean headlight lenses regularly from dirt and road reagents. Use special tools (for example, Sonax Glass Cleaner), so as not to damage the coating.
• 🔄 Check the light adjustment every 10,000 km. Incorrectly adjusted PTFs blind oncoming drivers.
• 🔋 Change lamps in pairs, even if only one burned out. This will ensure even lighting.
• 🌡️ Avoid turning on PTF in hot weather - this shortens the life of the lamps and can lead to melting of the plastic housing of the headlight.

To adjust the fog lights, use the following diagram:

1. Place the car on a flat area 5 meters from the wall.

2. Turn on the fog lights and mark the center of the light spots on the wall.

3. Adjust the screws on the headlight housing so that the light spots are 10–15 cm below the level of the low beam headlights.

If the headlight lenses are cloudy, they can be polished using a set 3M Headlight Restoration Kit. This will restore transparency and improve light transmission by 30–40%.

FAQ: answers to frequently asked questions

Is it possible to drive with the fog lights on instead of the low beams?

No, this is a traffic violation (Article 12.20 of the Administrative Code). Fog lights can be used only together with side lights or low beams. The exception is driving in conditions of poor visibility (fog, rain, snowfall), when PTF can be used separately.

Which fuse is responsible for the fog lights on the Tiida J32?

This is the fuse for the front fog lights. F37 (10A), for the rear - F38 (10A). They are located in the fuse box under the steering wheel (driver's side). It is recommended to always carry spare fuses with you, as they often blow out during power surges.

What to do if the fog lights are on full blast?

This is a sign of one of three problems:

1. Poor contact in the lamp socket or fuse box. Check and clean contacts.
2. Wiring oxidation. Test the circuit with a multimeter.
3. Lamp wear. Replace it with a new one (even if the thread is visually intact).

If the problem remains, check the voltage on the lamp with the PTF on. It must be no less 12V.

Is it possible to install LED lamps in Tiida fog lights?

Technically yes, but there are some nuances:

• 🔹 Legal aspect: in Russia, the use of LED lamps in PTF is not certified, which can lead to problems during maintenance.
• 🔹 Technical aspect: LEDs require correct polarity and may cause errors on the instrument panel (eg CHECK BULB).
• 🔹 Luminous flux: Cheap LED lamps often blind oncoming drivers due to the wrong light beam.

If you decide to replace, choose lamps with a conformity mark ECE R19 (For example, Osram LEDriving FOG).

Where to buy original fog lights for Tiida?

Original fog lights for Nissan Tiida can be purchased:

• 🛒 From an official dealer (article for front PTF: 26550-JM00A, for the rear: 26450-JM00A).
• 🔧 At the showdown (for example, on Avito or Drom.ru in the "Spare parts" section).
• 🌍 In online stores (For example, Exist.ru, Autodoc.ru, Emex.ru).

Average price of original PTFs: 3,000–5,000 rubles per pair. Analogs (for example, Depo or TYC) will cost 1,500–2,500 rubles.