Location of fuses on Nissan Qashqai: where to look and how to replace

Owners Nissan Qashqai sooner or later you have to face the need to check or replace fuses. The operation of all electrical equipment depends on their serviceability - from headlights to the climate control system. But where exactly are these elements located in different generations of the crossover? In this article you will find exact layout diagrams, description of fuse blocks for Qashqai J10 (2006–2013), J11 (2013–2021) and J12 (from 2021), as well as practical advice on diagnostics and replacement.

We will not just list the places where the fuses are located, but also explain how remove them correctly, what to look for when buying new ones, and what mistakes car owners most often make. If your cigarette lighter, power windows or radio stop working, don’t rush to go to the service center. In 80% of cases, the problem is solved by replacing the fuse in 5 minutes.

Where are the fuse boxes in the Nissan Qashqai: main locations

B Nissan Qashqai fuses and relays are distributed over several blocks. Their number and location depend on the generation and equipment of the car. However there is three key placeswhere to look first:

• 🔧 Main unit in the cabin - usually located to the left of the steering column, behind the plastic cover. Fuses for most systems (lighting, audio system, cigarette lighter) are concentrated here.
• 🚗 Block under the hood - located next to the battery or in a special compartment on the left side of the engine compartment. Responsible for powerful consumers: fans, starter, ABS.
• 🔌 Additional unit in the trunk - not present in all versions, but in Qashqai J11 And J12 can be placed behind the casing on the right side.

B Qashqai J10 (first generation) fuse blocks are simpler in design, and in J11 And J12 their number has increased due to the growth in the number of electronic systems. For example, in J12 a separate block for systems appeared ADAS (driver assistant), which is located behind the glove compartment.

Nissan Qashqai interior fuse diagram (J10, J11, J12)

The most accessible fuse box is located in the passenger compartment. To get to it:

1. Open the driver's door and crouch down to see the left side of the instrument panel.
2. Find the plastic cover that says FUSE or fuse pictogram.
3. Carefully pry the cover off with a screwdriver or your fingers - it is held in place by latches.

Under the cover you will see a fuse and relay box. Their decoding differs depending on the generation:

Generation	Fuse number	Purpose	Denomination (A)
Qashqai J10	F1	Cigarette lighter	15
	F7	Low beam (left)	10
	F10	Audio system	10
Qashqai J11	F22	USB/aux ports	10
	F30	Window lifters	20
	F45	Rear view camera	7.5

B Qashqai J12 The fuse box in the cabin is divided into two parts: the upper (main circuits) and the lower (additional options, for example, a heated steering wheel). If you don't find the fuse you need in the upper part, check the lower part - it is often hidden behind a second cover.

How to check a fuse without a tester?

If you don't have a multimeter at hand, you can visually inspect the fuse in the light. A burnt out one will have a broken thread inside or blackened contacts. You can also replace a suspicious fuse with a known working fuse of the same rating from another slot (for example, from a radio).

Fuse box under the hood: what is located there

In the engine compartment Nissan Qashqai The high power fuse and relay box is located. He is responsible for:

• ⚡ Starter and generator - fuses for 80–100 A.
• 🔥 Fuel injection system — chains of injectors and fuel pump.
• 🚨 ABS and ESP — relays and fuses for the anti-lock braking system.
• 💨 Cooling fans - often fail due to overheating.

To access this block:

1. Open the hood and locate the black plastic box next to the battery (at J10) or on the left side of the engine compartment (in J11/J12).
2. Press the latches and remove the cover.
3. Under the cover you will see a diagram with symbols - it may differ depending on the engine (1.6, 2.0, diesel 1.5 dCi).

Attention! Underhood fuses are often high rated (30-100A). Do not replace them with bugs or fuses of a lower rating - this may lead to fire in the engine compartment.

Decoding relays in Nissan Qashqai: which ones are responsible for what

Next to the fuses in the blocks there are relays - electromechanical devices that control powerful consumers. B Qashqai they are responsible for:

• 🔦 Headlights — low/high beam relay.
• 🔊 Beep - often fails when exposed to moisture.
• 🌀 Windshield wipers - wiper control relay.
• 🔋 Heated seats/mirrors - in versions with the option Comfort Pack.

The table below shows a typical relay decoding for Qashqai J11 (may differ in other generations):

Designation	Purpose	Symptoms of a problem
R1	Starter relay	Engine does not start, clicks when turning key
R5	Cooling fan relay	Engine overheating, fan does not turn on
R10	Fuel pump relay	Engine stalls and won't start
R14	Heated rear window relay	The heating threads do not work, there is no voltage at the contacts

If the relay fails, it can be replaced with a similar one from another slot (for example, the horn relay is often interchangeable with the windshield wiper relay). However, if the new relay burns out quickly, look for short circuit in the circuit.

Common problems with fuses in Nissan Qashqai

Some fuses in Qashqai burn out more often than others. Here TOP-5 problem areas:

1. Cigarette lighter (F1 or F22) — burns out due to the connection of powerful devices (vacuum cleaners, compressors). The nominal value is 15–20 A, but many owners set it to 25–30 A, which leads to melting of the contacts.
2. Window lift control unit (F30) — often suffers when glass freezes or mechanical blockages.
3. Audio system (F10 or F15) - fails when there is a short circuit in the speakers or when connecting a non-standard radio.
4. Cooling fan (40–50 A fuse under hood) - burns out when overheated or shorted in the circuit.
5. Rear view camera (F45) - sensitive to power surges, especially in rainy weather.

If the fuse blows again after replacement, don't increase its value! This may cause the wiring to melt. Instead:

• Check the circuit for short circuit with a multimeter.
• Inspect the connectors for moisture or corrosion.
• If the problem is in the cigarette lighter, use a splitter with a fuse.

⚠️ Attention! B Qashqai J12 with the system ProPILOT Some fuses are related to the operation of radar sensors. Replacing them with non-standard ones can disable driver assistants!

How to properly replace a fuse: step-by-step instructions

Replacing a fuse is a simple procedure, but there are some nuances here too. Follow this algorithm:

1. Turn off the ignition and remove the key. In some cases (for example, when working with a unit under the hood), it is better to disconnect the negative terminal of the battery.
2. Find the faulty fuse according to the diagram on the unit cover or in the instruction manual.
3. Remove the fuse with special tweezers (available in the unit) or pliers. Don't pull the wires!
4. Check the new fuse - it must be of the same denomination and type (knife, miniature, etc.).
5. Install the fuse until it clicks. Make sure it fits snugly in the socket.

Important points:

• 🔹 Do not use metal objects (screwdrivers, knives) to remove fuses - this may damage the contacts.
• 🔹 If the fuse is stuck, do not pull it by force. Spray contacts WD-40 and wait 5 minutes.
• 🔹B Qashqai J11 And J12 Some fuses are color coded (for example, red - 10 A, blue - 15 A). Don't ignore her!

FAQ: Frequently asked questions about fuses in Nissan Qashqai

Is it possible to install a fuse of a higher rating if it constantly blows?

No! Increasing the rating may lead to melted wiring or even a fire. If the fuse blows repeatedly, look for the cause - usually a short circuit or circuit overload (for example, when connecting a powerful device to the cigarette lighter).

Where can I find the fuse diagram for my version of Qashqai?

The diagram is usually marked on the inside of the fuse box cover. If it is not there, download the instruction manual for your year of manufacture on the official website Nissan or on forums (for example, qashqai-club.ru). For J12 diagrams may differ depending on the configuration (Visia, Acenta, Tekna).

What to do if the fuse is intact, but the device does not work?

Check:

1. The device itself (for example, a light bulb in a headlight or a radio tape recorder).
2. Relay associated with this circuit.
3. Wiring for breaks or corrosion (especially at connections).
4. The fuse is in another block (sometimes the circuits are duplicated).

If the problem persists, contact an auto electrician for diagnosis.

Which fuses are most likely to blow in a Qashqai J10?

In the first generation Qashqai Most often they fail:

• Cigarette lighter fuse (F1, 15 A) - due to the connection of non-standard devices.
• Low beam fuse (F7/F8, 10 A) - when installing LED lamps without a corrector.
• Audio fuse (F10, 10 A) - in case of a short circuit in the speakers.

Is it possible to repair the fuse box yourself if the contacts are melted?

If only the fuse contacts are melted, they can be carefully cleaned with sandpaper or a file. If the block itself has melted, it is better to replace it entirely, since restoring contacts at home is unreliable. B Qashqai J11 And J12 Fuse blocks often come complete with relays, and replacing them requires removing the instrument panel.